An experimental monitoring system was installed on an operational heavy haul rail track. The system used two piezoelectric transducers mounted under the head of the rail to transmit and receive ultrasonic guided waves in pulse-echo mode and data were captured over a 2-week period. An artificial defect was introduced by glueing a small mass under the head of the rail at a distance of 370 m from the transducers. The size of the signal reflected by the mass varied as the glue joint deteriorated. The measurements were reordered to simulate a monotonically growing defect. The pre-processing of the captured time signals included averaging, filtering, phased array processing, dispersion compensation, signal stretching and amplitude scaling. Singular value decomposition and independent component analysis of the data were performed. Independent component analysis, with dimension reduction achieved by retaining only the larger principal components, produced the best defect detection. The defect signature was separated as an independent component, and the weight of this component increased monotonically. The results indicate that a transverse defect in the rail head could be detected and located at long range by a system comprising only two transducers. The variation of the signals due to changing environmental and operational conditions limits the size of defect that can be detected, but it is expected that even a relatively small defect, which is significantly smaller than the critical size, would be detected.
3 July 2012 in Journal of Nondestructive Evaluation
A numerical method for computing the time response of infinite constant cross-section elastic waveguides excited by piezoelectric transducers was developed. The method combined waveguide finite elements (semi-analytical finite elements) for modeling the waveguide with conventional 3-D piezoelectric finite elements for modeling the transducer. The frequency response of the coupled system was computed and then used to simulate the time response to tone-burst electrical excitation. A technique for identifying and separating the propagating modes was devised, which enabled the computation of the response of a selected reduced number of modes. The method was applied to a rail excited by a piezoelectric patch transducer, and excellent agreement with measured responses was obtained. It was found that it is necessary to include damping in the waveguide model if the response near a ldquocut-onrdquo frequency is to be simulated in the near-field.