This paper presents the design of a highly efficient pneumatic motor system. The air engine is currently the most generally used device to convert potential energy of compressed air into mechanical energy. However, the efficiency of the air engines is too low to provide sufficient operating range for the vehicle. In this study, the energy contained in compressed air/pressurized hydraulic oil is transformed by a hydraulic motor to mechanical energy to enhance the efficiency of using air power. To evaluate the theoretical efficiency, the principle of balance of energy is applied. The theoretical efficiency of converting air into hydraulic energy is found to be a function of pressure; thus, the maximum converting efficiency can be determined. To confirm the theoretical evaluation, a prototype of the pneumatic hydraulic system is built. The experiment verifies that the theoretical evaluation of the system efficiency is reasonable, and that the layout of the system is determined by the results of theoretical evaluation.
A hydrostatic journal bearing with porous pads to improve its performance is designed. The porous pads, which are embedded in recesses of the hydrostatic journal bearing, not only allow lubricant to flow through them but also form a complete cylindrical surface with the bearing land. The load capacity of the hydrostatic bearing is thus maintained and the hydrodynamic effects strengthened. A theoretical model of the porous pads bearing is tested with the simulation software, and the parameters that critically affect the bearing performance are studied. Thus, the results obtained indicate that the porous pads bearing has higher load capacity and higher stiffness than a typical hydrostatic bearing with lower friction and lower end flow rate at high rotating speed.
In this study a highly efficient compressed air driven hydraulic motor system is designed, developed and tested. The basic concept of using a hydraulic motor to transform the energy of compressed air (which compressing the hydraulic oil) to mechanical energy is developed, which can use the energy in compressed air more efficiently than the traditional piston type air engine. However, due to the air pressure exhale from the converter still has some energy. To recover the energy, a booster is used to recover the energy. In this study, both theoretical model and experiment device of the system are developed; several experiments to validate the theoretical model are made. It was found that the efficiency of the system is good when using the booster.
In this study, a double-wheel self balanced unicycle is proposed. Because of the shortage of energy resource and parking space in city, the idea of this light-weight electrical aid personal unicycle can hopefully be used in future transportation system. The unicycle has the features of small longitudinal length, with two coaxial wheels and pedal by human with electric control system to balance the unicycle. It is known that when the rider rides the unicycle, the paddle force disturbs the balance of the vehicle. This unbalance force comes from the gravity center is not at the point of the ground contact points of the vehicle. To balance the unbalance force, two servo-motors to drive the two wheels are used. The unbalance condition is detected by sensors. A transmission mechanism to combine human power and electric power is designed. Planetary gear set is considerable to be the basic concept of transmission mechanism design. The sequence of study processes would be helpful to design the layout of the transmission about chassis, bike frame, and wheels. The mechanism design could link up the mechanical system with the motors and electro-control system.