In this paper, direct observation of micromotion for multiple ions in a laser-cooled trapped ion crystal is discussed along with a measurement technique for micromotion amplitude. Micromotion is directly observed using a time-resolving, single-photon-sensitive camera that provides both fluorescence and position data for each ion on the nanosecond time scale. Micromotion amplitude and phase for each ion in the crystal are measured, allowing this method to be sensitive to tilts and shifts of the ion chain from the null of the radio-frequency quadrupole potential in the linear trap. Spatial resolution makes this micromotion detection technique suitable for complex ion configurations, including two-dimensional geometries. It does not require any additional equipment or laser beams, and the modulation of the cooling lasers or trap voltages is not necessary for detection as it is in other methods.
Atomic cadmium ions are loaded into radiofrequency ion traps by photoionization of atoms in a cadmium vapor with ultrafast laser pulses. The photoionization is driven through an intermediate atomic resonance with a frequency-quadrupled mode-locked Ti:sapphire laser that produces pulses of either or duration at a central wavelength of . The large bandwidth of the pulses photoionizes all velocity classes of the Cd vapor, resulting in a high loading efficiency compared to previous ion trap loading techniques. Measured loading rates are compared with a simple theoretical model, and we conclude that this technique can potentially ionize every atom traversing the laser beam within the trapping volume. This may allow the operation of ion traps with lower levels of background pressures and less trap electrode surface contamination. The technique and laser system reported here should be applicable to loading most laser-cooled ion species.
We study the Doppler-cooling of radial two-dimensional (2D) Coulomb crystals of trapped barium ions in a radiofrequency trap. Ions in radial 2D crystals experience micromotion of an amplitude that increases linearly with the distance from the trap center, leading to a position-dependent frequency modulation of laser light in each ion's rest frame. We use two tones of Doppler-cooling laser light separated by approximately 100 MHz to efficiently cool distinct regions in the crystals with differing amplitudes of micromotion. This technique allows us to trap and cool more than 50 ions populating four shells in a radial 2D crystal, where with a single tone of Doppler cooling light we are limited to 30 ions in three shells. We also individually characterize the micromotion of all ions within the crystals and use this information to locate the center of the trap and to determine the Matthieu parameters and .
We have developed a vacuum chamber and control system for rapid testing of microfabricated surface ion traps. Our system is modular in design and is based on an in-vacuum printed circuit board with integrated filters. We have used this system to successfully trap and cool barium ions and have achieved ion ‘dark' lifetimes of 31.6 s ± 3.4 s with controlled shuttling of ions. We provide a detailed description of the ion trap system including the in-vacuum materials used, control electronics and neutral atom source. We discuss the challenges presented in achieving a system which can work reliably over two years of operations in which the trap under test was changed at least 10 times.
Qubit state detection is an important part of a quantum computation. As the number of qubits in a quantum register increases, it is necessary to maintain high-fidelity detection to accurately measure the multiqubit state. Here we present experimental demonstration of high-fidelity detection of a multiqubit trapped-ion register with an average single-qubit detection error of 4.2(1.5) ppm and a four-qubit state detection error of 17(2) ppm, limited by the decay lifetime of the qubit, using a single-photon-sensitive camera with fast data collection, excellent temporal and spatial resolution, and low instrumental crosstalk.
We recently accelerated a polarized proton beam from 95 to 380 MeV through both the imperfection depolarizing resonance and the intrinsic depolarizing resonance. The imperfection resonance flipped the spin, while the intrinsic resonance initially caused partial depolarization. We then pulsed a vertical kicker magnet for about 500 ns to increase the beam's vertical betatron amplitude; this made the intrinsic resonance much stronger. By varying the strength and start time of the kicker, we observed a sharp spin flip due to the now very strong intrinsic depolarizing resonance.