Ragini Acharya

Prof. Dr. Ragini Acharya


Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 March 2012
Verified
Book
Open access
KKKenneth K. Kuo
Kenneth K. Kuo
RARagini Acharya
Ragini Acharya
Click on the title to browse this book

1 November 2007 in Journal of Propulsion and Power
Verified
Journal Article
Closed access
RARagini Acharya
Ragini Acharya
KKKenneth K. Kuo
Kenneth K. Kuo

13 April 2012
Verified
Book
Open access
KKKenneth K. Kuo
Kenneth K. Kuo
RARagini Acharya
Ragini Acharya
Click on the title to browse this book

25 October 2004 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
PDF file
MAM. Alam
M. Alam
JSJ. Song
J. Song
RARagini Acharya
Ragini Acharya
ABA. Boehman
A. Boehman
KMK. Miller
K. Miller
Experiments were conducted with a commercially available six-cylinder, 4-valves per cylinder, turbocharged, direct injection (DI) diesel engine. The engine was operated with low sulfur diesel fuel, ultra low sulfur diesel fuel and two other blends, low sulfur diesel fuel with 20 wt.% biodiesel and ultra low sulfur diesel fuel with 20 wt.% biodiesel, to investigate the effect of the base fuels and their blends on combustion and emissions. Combustion analysis, particulate matter emissions and exhaust gas composition (CO, NOX and total hydrocarbons) were determined at eight steady-state operating conditions according to the AVL 8-Mode test protocol. Combustion analysis showed at high load conditions a retarded start of injection, an earlier start of combustion and a lower premixed burn peak with ultra low sulfur diesel fuel. Mode averaged NOX emissions decreased with ultra low sulfur diesel fuel and biodiesel blends compared to low sulfur diesel fuel. A 20% PM reduction was observed with ultra low sulfur (15 PPM) diesel fuel compared to low sulfur (325 PPM) diesel fuel.

17 May 2010 in Journal of Applied Mechanics
Verified
Journal Article
Closed access
PDF file
RARagini Acharya
Ragini Acharya
KKKenneth Kuo
Kenneth Kuo

3 April 2006 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
PDF file
RARagini Acharya
Ragini Acharya
MAM. Alam
M. Alam
ABA. L. Boehman
A. L. Boehman
This work considers the performance of a NOx control system on a diesel engine and the interaction between the NOx and particulate control devices. A commercial urea-selective catalytic reduction (SCR) catalyst (twin catalytic reactors used in series) was characterized for the impact of nitrogen dioxide (NO2) on the ammonia consumption, production of nitrous oxide (N2O) and relative selectivity of the urea-SCR catalyst for NO2 versus NO when the SCR reactors were positioned downstream of a catalyzed diesel particulate filter (DPF). The aqueous urea solution was injected into the exhaust by using a twin fluid, air-assisted atomizer. It was possible to observe the role of NO2 due to the catalyzed diesel particulate filter (DPF) upstream of the SCR catalyst. This catalyzed DPF oxidizes nitric oxide (NO) in the engine-out emissions to NO2. Further, it uses NO2 to oxidize particulate matter (PM). But depending on the catalyst temperature and PM accumulation, the NO2 generation and consumption varies. Therefore, the net NO2 in the exhaust feed that enters the SCR catalyst can be significantly higher than the baseline engine-out emissions. This phenomenon provided an excellent opportunity to examine the relative selectivity of the SCR catalyst for both nitrogen oxides, NO and NO2, as well as, to observe the impact of NO2 on NH3 consumption. The results show the significant effect of NO2 on the overall performance and efficiency of the SCR system. It is shown that the urea-SCR catalyst has higher selectivity for NO2 than NO and in presence of NO2, the NH3 requirement for complete removal of NOx changes. The results show that the urea-SCR catalytic process does not form N2O, which can be an undesired byproduct of catalytic NOx control.