This study explores the mechanisms responsible for the bandwidth reduction observed in germanium photodetectors under high signal light power. We investigate the impact of the carrier-shielding effect on the bandwidth through simulations, and we mitigate this effect by increasing the applied bias voltage. The increase in the concentration of photogenerated carriers leads to a reduction in the carrier saturation drift velocity, which reduces the bandwidth of the germanium photodetector; this phenomenon is studied for the first time. The bandwidth is determined primarily by the carrier saturation drift velocity when the incident light power is below 2.5 mW. The decrease in bandwidth that is calculated based on the decrease in carrier saturation drift velocity is consistent with the experimental results. However, when the signal light power exceeds 3 mW, both the carrier-shielding effect and the reduction in the carrier saturation drift velocity contribute to the bandwidth reduction. This study provides good theoretical guidance for the design of high-power germanium photodetectors.
In this paper, the structure of the silicon modulator is optimized by asymmetric slab design to enhance overall performance. Recognizing the inherent disparity in electron and hole mobilities in silicon, we propose and systematically investigate asymmetric slab designs where the n-type slab width is varied relative to the p-type slab. We demonstrate that optimally scaling the n-type slab width to 2.8 times that of the p-type slab effectively synchronizes the charging/discharging dynamics of the PN junction. This optimized design achieves a significant bandwidth enhancement to 35.73 GHz, a 3.01 GHz increase over the conventional symmetric design. Crucially, this performance gain is attained while maintaining comparable modulation efficiency and reducing optical loss. Finally, the asymmetric slab structure proposed in this paper is applicable to almost all PN junction devices.