Understanding the environmental fate of microplastics is essential for their risk assessment. It is essential to differentiate size classes and degradation states. Still, insights into fragmentation and degradation mechanisms of primary and secondary microplastics into micro- and nanoplastic fragments and other degradation products are limited. Here, we present an adapted NanoRelease protocol for a UV-dose-dependent assessment and size-selective quantification of the release of micro- and nanoplastic fragments down to 10 nm and demonstrate its applicability for polyamide and thermoplastic polyurethanes. The tested cryo-milled polymers do not originate from actual consumer products but are handled in industry and are therefore representative of polydisperse microplastics occurring in the environment. The protocol is suitable for various types of microplastic polymers, and the measured rates can serve to parameterize mechanistic fragmentation models. We also found that primary microplastics matched the same ranking of weathering stability as their corresponding macroplastics and that dissolved organics constitute a major rate of microplastic mass loss. The results imply that previously formed micro- and nanoplastic fragments can further degrade into water-soluble organics with measurable rates that enable modeling approaches for all environmental compartments accessible to UV light.

Multi-walled carbon nanotubes (MWCNTs) are commonly used in polymer formulations to improve strength, conductivity, and other attributes. A developing concern is the potential for carbon nanotube polymer nanocomposites to release nanoparticles into the environment as the polymer matrix degrades or is mechanically stressed. Here, we review characteristics related to release potential of five sets of polymer systems: epoxy, polyamide, polyurethane, polyethylene, and polycarbonate. Our review includes consideration of general characteristics and use of the polymer (as related to potential MWCNT release) and its MWCNT composites; general potential for nanomaterial release (particularly MWCNTs) due to degradation and mechanical stresses during use; and potential effects of stabilizers and plasticizers on polymer degradation. We examine UV degradation, temperature extremes, acid-base catalysis, and stresses such as sanding. Based on a high-level summary of the characteristics considered, the potential for release of MWCNT with typical, intended consumer use is expected to be low. \ua9 2013 Elsevier Ltd. All rights reserved.Peer reviewed: YesNRC publication: Ye