Thomas Blenkinsop

Prof. Thomas Blenkinsop

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 July 2019 in Geochemistry, Geophysics, Geosystems
Verified
Journal Article
Open access
PDF file
JWJack N. Williams
Jack N. Williams
AFAke Fagereng
Ake Fagereng
LWLuke N. J. Wedmore
Luke N. J. Wedmore
JBJuliet Biggs
Juliet Biggs
FMFelix Mphepo
Felix Mphepo
TBThomas Blenkinsop
Thomas Blenkinsop
Crustal extension is commonly thought to be accommodated by faults that strike orthogonal and obliquely to the regional trend of the minimum compressive stress (σ3). Activation of oblique faults can, however, be conceptually problematic as under Andersonian faulting, it requires preexisting crustal weaknesses, high fluid pressures, and/or stress rotations. Furthermore, measurements of incremental fault displacements, which are typically used to identify oblique faulting, do not necessarily reflect regional stresses. Here, we assess oblique faulting by calculating the stress ratio (σ3/σ1, where σ1 is the maximum compressive stress), slip tendency, and effective coefficient of friction (μs′) required to reactivate variably striking normal faults under different trends of σ3. We apply this analysis to NW and NNE striking active faults at the southern end of the Malawi Rift, where NE‐SW, ENE‐WSW, E‐W, and SE‐NW σ3 trends have previously been proposed. A uniform σ3 trend is inferred for this region as recent joints sets do not rotate along the rift. With a NE‐SW trending σ3, NW‐striking faults are well oriented, however, NNE‐striking faults require μs′ < 0.6 to reactivate. This is inconsistent with a lack of frictionally weak phyllosilicates detected in the fault zone rocks. With an ENE‐WSW to E‐W trending σ3, all faults can reactivate at μs′ > 0.55. These σ3 trends are also comparable to a focal mechanism stress inversion, regional joint orientations, and previously reported geodetically derived extension directions. We therefore conclude that unlike typical models of oblique rifting, the southern Malawi Rift consists of faults that all strike slightly oblique to σ3.

19 February 2018 in Basin Research
Verified
Journal Article
Open access
PDF file
NWNicholas I. P. Ward
Nicholas I. P. Ward
TATiago M. Alves
Tiago M. Alves
TBThomas Blenkinsop
Thomas Blenkinsop
The control of slide blocks on slope depositional systems is investigated in a high‐quality 3D seismic volume from the Espírito Santo Basin, SE Brazil. Seismic interpretation and statistical methods were used to understand the effect of differential compaction on strata proximal to the headwall of a blocky mass‐transport deposit (MTD), where blocks are large and undisturbed (remnant), and in the distal part of this same deposit. The distal part contains smaller rafted blocks that moved and deformed with the MTD. Upon their emplacement, the positive topographic relief of blocks created a rugged seafloor, confining sediment pathways and creating accommodation space for slope sediment. In parallel, competent blocks resisted compaction more than the surrounding debrite matrix during early burial. This resulted in differential compaction between competent blocks and soft flanking strata, in a process that was able to maintain a rugged seafloor for >5 Ma after burial. Around the largest blocks, a cluster of striations associated with a submarine channel bypassed these obstructions on the slope and, as a result, reflects important deflection by blocks and compaction‐related folds that were obstructing turbidite flows. Log‐log graphs were made to compare the width and height of different stratigraphic elements; blocks, depocentres and channels. There is a strong correlation between the sizes of each element, but with each subsequent stage (block–depocentre–channel) displaying marked reductions in height. Blocky MTDs found on passive margins across the globe are likely to experience similar effects during early burial to those documented in this work.

4 January 2022 in Solid Earth
Verified
Journal Article
Open access
PDF file
MPManuel I. de Paz-Álvarez
Manuel I. de Paz-Álvarez
TBThomas Blenkinsop
Thomas Blenkinsop
DBDavid M. Buchs
David M. Buchs
GGGeorge E. Gibbons
George E. Gibbons
LCLesley Cherns
Lesley Cherns
The restrictions implemented to contain the spread of the COVID-19 pandemic during 2020 and 2021 have forced university-level educators from around the world to seek alternatives to the residential physical field trips that constitute a fundamental pillar of Geoscience programmes. The field-mapping course for second-year Geology BSc students from Cardiff University was replaced with a virtual mapping course set in the same area as previous years, the Esla Nappe (Cantabrian Zone, NW Spain). The course was designed with the aim of providing the students with the same methodology employed in physical mapping, including such skills as gathering discrete data at stops located along five daily itineraries. Data included bedding attitude, outcrop descriptions with a certain degree of ambiguity, photographs and/or sketches, panoramic photos, and fossil images. Data were provided to the students through georeferenced KMZ files in Google Earth. Students were asked to keep a field notebook, define lithological units of mappable scale, identify large structures such as thrust faults and folds with the aid of age estimations from fossils, construct a geological map on a hard-copy topographic map, draw a stratigraphic column and cross sections, and plot the data in a stereonet to perform structural analysis. The exercise allowed for successful training of diverse geological field skills. In light of the assessment of reports and student surveys, a series of improvements for the future is considered. Though incapable of replacing a physical field course, the virtual exercise could be used in preparation for the residential field trip.

1 January 2020
Verified
Book Chapter
Closed access
TBThomas Blenkinsop
Thomas Blenkinsop
NON.H.S. Oliver
N.H.S. Oliver
PDP.G.H.M. Dirks
P.G.H.M. Dirks
MNM. Nugus
M. Nugus
GTG. Tripp
G. Tripp
DRDavid A. Rhys
David A. Rhys
The structural geology and tectonic setting of hydrothermal gold deposits are paramount for understanding their genesis and for their exploration. Strong structural control on mineralization is one of the defining features of these deposits and arises because the permeabilities of crustal rocks are too low to allow the formation of hydrothermal deposits on realistic timescales unless rocks are deformed. Deformation zones and networks of deformation zones are the fundamental structures that control mineralization. Systematically analyzing deposit geometry, kinematics, and dynamics leads to the most thorough comprehension of a deposit. Geometric analysis relates orebody shape to controlling structures, and networks of deformation zones can be analyzed using topology to understand their connectivity and mineralizing potential. Kinematic analysis determines the location of permeability creation and mineralization. New views of shear zone kinematics allow for variable ratios of pure to simple shear, which change likely directions of mineralization. Multiple orientations of mineralized deformation zones may form simultaneously and symmetrically about the principal strain axes. Dynamic analysis is necessary for a mechanical understanding of deformation, fluid flow, and mineralization and can be achieved through numerical modeling. The relationship between deformation (kinematics) and stress (dynamics) constitutes the rheology; rheological contrasts are critical for the localization of many deposits. Numerous gold deposits, especially the largest, have evidence for multiple mineralizing events that may be separated by tens to hundreds of millions of years. In these cases, reactivation of structures is common, and a range of orientations of preexisting structures are predicted to be reactivated, given that they are weaker than intact rock. Physical and chemical processes of mineralization can be integrated using a nonequilibrium thermodynamics approach. Hydrothermal gold deposits form in contractional, strike-slip, and extensional tectonic settings. However, there may be great variation in the spatial scale over which the tectonic setting applies, and tectonic settings may also change on rapid timescales, so that it is inadvisable to infer local tectonics from deposit-scale patterns, and vice versa. It is essential to place mineralizing events within a complete geologic history in order to distinguish pre- and postmineralizing structures from synmineralization deformation features.

23 December 2023 in Journal of Structural Geology
Verified
Journal Article
Open access
SCSara De Caroli
Sara De Caroli
AFAke Fagereng
Ake Fagereng
KUKohtaro Ujiie
Kohtaro Ujiie
TBThomas Blenkinsop
Thomas Blenkinsop
FMFrancesca Meneghini
Francesca Meneghini
DMDuncan Muir
Duncan Muir

1 June 2010 in Journal of Structural Geology
Verified
Journal Article
Closed access
TBThomas Blenkinsop
Thomas Blenkinsop
MDM.G. Doyle
M.G. Doyle