The microbiological sanitary quality and safety of leafy greens and strawberries were assessed in the primary production in Belgium, Brazil, Egypt, Norway and Spain by enumeration of Escherichia coli and detection of Salmonella, Shiga toxin-producing E. coli (STEC) and Campylobacter. Water samples were more prone to containing pathogens (54 positives out of 950 analyses) than soil (16/1186) and produce on the field (18/977 for leafy greens and 5/402 for strawberries). The prevalence of pathogens also varied markedly according to the sampling region. Flooding of fields increased the risk considerably, with odds ratio (OR) 10.9 for Salmonella and 7.0 for STEC. A significant association between elevated numbers of generic E. coli and detection of pathogens (OR of 2.3 for STEC and 2.7 for Salmonella) was established. Generic E. coli was found to be a suitable index organism for Salmonella and STEC, but to a lesser extent for Campylobacter. Guidelines on frequency of sampling and threshold values for E. coli in irrigation water may differ from region to region.
1 September 2013 in Brazilian Journal of Microbiology
Staphylococcal food poisoning is one of the most frequent foodborne illnesses worldwide and it is caused by the ingestion of food contaminated with enterotoxins produced by some strains of Staphylococcus (S.) aureus. In the State of Rio Grande do Sul (RS), Southern Brazil, S. aureus has been identified as the second most frequent agent of foodborne illnesses in the last two decades. The aim of the present study was to assess and analyse the epidemiological data of S. aureus food poisoning occurred in the State of RS during the years of 2000 to 2002. The official records of epidemiological investigations carried out by the Sanitary Surveillance Services of the State of RS were analysed. Among foodborne outbreaks for which aetiology was determined, S. aureus was identified as the responsible agent of 57 foodborne outbreaks, being 42 (74%) confirmed by microbiological analyses and 15 (26%) confirmed by clinical symptoms and/or epidemiological data. Staphylococcal outbreaks were responsible for the exposition of 5,991 persons, of which 1,940 (32%) were interviewed by the Sanitary Surveillance officers. The most affected age group corresponded to people with 20 to 49 years old (48%), where men (48%) and women (52%) were affected similarly. The main involved food vehicles were meats servings (35%), followed by pastries (25%), cheese (23%), pasta (11%) and potato salad with homemade mayonnaise (11%). The majority of the outbreaks occurred inside private homes (33%) followed by commercial food establishments (28%). Inadequate control of temperature and failures in general hygiene practices were identified as the main factors responsible for the outbreaks. In conclusion, S. aureus was an important food poisoning etiological agent in the State of RS during 2000 to 2002 and its prevention depends on control measures involving different parts of the food chain.
Salmonella strains (n = 75) isolated from foods involved in foodborne outbreaks occurred in Rio Grande do Sul State, Brazil, during 1999 and 2000 were studied. Strains were serotyped and submitted ...
1 December 2010 in Brazilian Journal of Microbiology
The adhesion of Salmonella (S.) strains to stainless steel and polyethylene and their inactivation by biocides used in food industry was investigated. Coupons of stainless steel and polyethylene were immersed in bacterial suspensions of S. Enteritidis, S. Typhimurium, and S. Bredeney during 15, 30, and 60 minutes, and submitted to different concentrations of peracetic acid (PAA), sodium hypochlorite (NaOCl), and quaternary ammonium (Quat) sanitizers. Hydrophobicity of the surfaces was evaluated by contact angle measurements using the sessile drop method and bacterial adhesion was accompanied through bacterial counts and scanning electron microscopy (SEM). Results indicated that the three serovars of Salmonella presented similar adhesion to both materials (5.0 to 6.5 log cfu cm-2). The time of exposure did not influence the counts of adhered cells on both surfaces, however SEM revealed larger clusters of S. Enteritidis on both materials, not found for the other serovars. S. Enteritidis presented lower sessile drop angle on polyethylene, indicating hydrophilic properties of this material. The biocides were not able to inactivate all the microorganisms adhered on both surfaces. At least 1 log cfu cm-2 of all serovars tested remained viable after the exposure to different biocide concentrations. In general, higher counts of survivors were observed on polyethylene disinfected with different concentrations of biocides. S. Bredeney e S. Typhimurium were more resistant than S. Enteritidis to PAA, whilst S. Enteritidis presented smaller reduction rates to NaOCl. This last biocide was able to reduce Salmonella counts in approximately 3.0 to 4.0 log cm-2. When adhered to polyethylene, the serovars S. Typhimurium and S. Enteritidis were more resistant to Quat than S. Bredeney in all concentrations tested, and the numbers of S. Enteritidis remained almost unaltered. On stainless steel disinfected by Quat, S. Bredeney presented higher numbers of survivors
14 March 2013 in The Journal of Infection in Developing Countries
Introduction: Contaminated sponges might lead to cross-contamination in kitchens since they can transfer microorganisms to surfaces where microorganisms can survive for hours or days and contaminate food. The main objective of this study was to evaluate the transfer and the survival of bacteria from kitchen sponges to surfaces of AISI 316 stainless steel and polyethylene. Methodology: Twenty-four sponges were collected from industrial kitchens in the state of Rio Grande do Sul and aseptically split into two equal parts. One part was subjected to enumeration of heterotrophic microorganisms, faecal coliforms, coagulase-positive Staphylococcus and search detection of Salmonella enterica. The other part was rubbed on surfaces of AISI 316 stainless steel (12 sponges) or polyethylene (12 sponges). The transfer and survival of microorganisms was quantified by swab collection and pour-plate method using plate count agar. Results: All sponges were contaminated by heterotrophic microorganisms (average of 6.8 log CFU/sponge) and 83.3% with faecal coliforms (average of 5 log CFU/sponge). None of the sponges were contaminated by S. enterica and/or coagulase-positive Staphylococcus. The average transfer of microorganisms varied between 3.3 and 5.5 log CFU/cm2 for stainless steel and from 3.5 to 5.6 log CFU/cm2 for polyethylene. Although the survival rate decreased over time, more than 1 log CFU/cm2 of heterotrophic microorganisms survived after 24 hours on both surfaces. Conclusions: The sponges used in food services were significantly contaminated and could transfer large amounts of microorganisms to surfaces of AISI 316 stainless steel and polyethylene.