TiO2 micro-/nano-structures with different morphologies have been successfully synthesized via a hydrothermal method. The effects of the solvents on the morphology and structure of the obtained products have been studied. The objective of the present paper is to compare the photocatalytic properties of the obtained TiO2 products. During the synthesis process, the tetrabutyl titanate and titanium (IV) fluoride were used as the titanium source. The obtained micro-/nano-structures were characterized by field-emission scanning electron microscopy, X-ray diffraction analysis, and nitrogen adsorption-desorption isotherms. The photocatalytic activity of the samples was evaluated by the degradation of Rhodamine B solution under simulated solar irradiation. It is found that the morphologies and structures of TiO2 have a great influence on its photocatalytic activity. Compared with other samples, TiO2 flower clusters assembled with nanorods exhibited a superior photocatalytic activity in the degradation of Rhodamine B.
TiO 2 ‐WO 3 hollow spheres were successfully fabricated by a two‐step synthesis method, which combines the polystyrene template‐assisted method and chemical deposition method. Scanning electron microscope, energy dispersive spectrometer, and X‐ray diffractometer were used to characterise the obtained products. The results indicate that the as‐fabricated nanocomposites are double‐shelled TiO 2 ‐WO 3 hollow spherical structures. The photocatalytic properties of the obtained products were determined by the degradation of rhodamine B aqueous solution under simulated solar irradiation. The results reveal that the TiO 2 ‐WO 3 hollow spheres and pure TiO 2 hollow spheres all have superior photocatalytic degradation ability. Compared with P25 nanoparticles and TiO 2 hollow spheres, TiO 2 ‐WO 3 hollow spheres exhibit the best photocatalytic performance.
10 March 2018 in Research on Chemical Intermediates
The synthesis of three-dimensional tungsten trioxide hydrate (WO3.H2O) films assembled by two-dimensional nanosheets has been realised through a seed assisted process at low temperature. The morphology of the film was observed with a field emission scanning electron microscope. The results indicate that the morphology of the film can be controlled by changing the concentration of chemicals used in the deposition process and the reaction time. Based on the experimental observations, a formation mechanism has been proposed. X-ray diffraction study indicates that these films have orthorhombic structure and are well crystallised. After heat treatment, the films transform to monoclinic WO3. In order to investigate the photocatalytic activity, the WO3 films were coated with stearic acid (SA), and their water contact angle was found to be 64° after coating. With the decomposition of SA molecules, the WO3 film switched to their initial hydrophilic state, accompanied by a reversible change of the film colour.
To improve the photocatalytic performance of tungsten oxide, attapulgite, used as supporter and adsorbent, was combined with tungsten oxide nanoparticles to form a kind of new photocatalyst. The photocatalyst (attapulgite/WO3) was prepared in a mild condition at 60ºC in an attapulgite/WCl6/ethanol/water system through alcoholysis and hydrolysis. The amount of WCl6 added in the chemical solution has an important influence on the morphology and structure of the products based on field emission scanning electron microscope and X-ray powder diffraction characterization. The photocatalytic activities of all the products were tested by degrading rhodamine B with the existence of H2O2. The result shows that the obtained attapulgite/WO3 nanocomposites have a great improvement in photocatalytic activity.