Lidars have gained a lot of popularity in the field of wind energy, partly because of their potential to be used for wind turbine control. By scanning the oncoming wind field, any threats such as gusts can be detected early and high loads can be avoided by taking preventive actions. Unfortunately, lidars suffer from some inherent weaknesses that hinder measuring gusts; e.g., the averaging of high-frequency fluctuations and only measuring along the line of sight). This paper proposes a method to construct a useful signal from a lidar by fitting a homogeneous Gaussian velocity field to a set of scattered measurements. The output signal, an along-wind force, acts as a measure for the damaging potential of an oncoming gust and is shown to agree with the rotor-effective wind speed (a similar control input, but derived directly from the wind turbine’s shaft torque). Low data availability and the disadvantage of not knowing the velocity between the lidar beams is translated into uncertainty and integrated in the output signal. This allows a designer to establish a control strategy based on risk, with the ultimate goal to reduce the extreme loads during operation.
1 June 2020 in Communications in Computational Physics
Communications in Computational Physics (CiCP) publishes original research and survey papers of high scientific value in computational modeling of physical problems. Results in multi-physics and multi-scale innovative computational methods and modeling in all physical sciences will be featured. CiCP is a refereed, interdisciplinary journal edited by a group of world-wide leading scientists in diverse fields to guarantee its highest standard. The journal is published in a timely fashion in printed and electronic forms.
The method of so-called constrained stochastic simulation is introduced. This method specifies how to efficiently generate time series around some specific event in a normal process. All events which can be expressed by means of a linear condition (constraint) can be dealt with. Two examples are given in the paper: the generation of stochastic time series around local maxima and the generation of stochastic time series around a combination of a local minimum and maximum with a specified time separation. The constrained time series turn out to be a combination of the original process and several correction terms which includes the autocorrelation function and its time derivatives. For the application concerning local maxima it is shown that the presented method is in line with properties of a normal process near a local maximum as found in literature. The method can e.g., be applied to generate wind gusts in order to assess the extreme loading of wind turbines
9 July 2009 in Journal of Solar Energy Engineering
Via so-called constrained stochastic simulation, gusts can be generated, which satisfy some specified constraint. In this paper, it is used in order to generate specific wind gusts, which will lead to local maxima in the response of wind turbines. The advantage of constrained simulation is that any gust amplitude (no matter how large) can be chosen. By performing simulations for different gust amplitudes and mean wind speeds, the distribution of the response is obtained. This probabilistic method is demonstrated on the basis of a generic 1 MW stall regulated wind turbine. By considering a linearized dynamic model of the reference turbine, the proposed probabilistic method could be validated. The determined 50 year response value indeed corresponds to the theoretical value (based on the work of Rice on random noise). Next, both constrained and (conventional) unconstrained simulations have been performed for the nonlinear wind turbine model. For all wind speed bins, constrained simulation results in 50 year estimates closer to the real value. Furthermore, via constrained simulation a lower uncertainty range of the estimate is obtained. The involved computational effort for both methods is about the same.
1 May 2026 in Journal of Physics: Conference Series
An easy method is presented to check a fatigue calculation just on the basis of a graph of the corresponding load time series. From the graph the largest load range should be determined. Next the ratio of the damage equivalent load and this load range should be compared to tabulated lower and upper bounds (depending on the slope of the stress-life curve). The lower bound is simply based on the largest range alone. The upper bound is analytical derived assuming the ranges are Rayleigh distributed. The bounds are verified on the basis of Gaussian time series and validated on the basis of a huge number of (Open)FAST simulations. Finally, it turned out that the method is robust for non-Gaussian load time series.