Agricultural irrigation strongly affects groundwater pollution in cultivated areas. Groundwater vulnerability was evaluated using the DRASTIC method by considering agricultural activities that affect water infiltration and pollutant transport to the groundwater. Three scenarios, using different water recharge sources and calculation methods, were considered for the Tongliao area of northern China. For Scenario 1, only precipitation contributed to the net recharge estimation and ~33.77% of the area was under high pollution risk. For Scenarios 2 and 3, both precipitation and irrigation return water were considered for net recharge estimations. The fractional areas of high pollution risk regions were 40.60% and 19.22% for Scenarios 2 and 3, respectively. The modified infiltration coefficients for this study area were used in Scenario 3, and the fractional area of the high-risk region was 21.38% lower than for Scenario 2. The use of empirical infiltration coefficients in Scenario 2 overestimated the water infiltration ability in the cultivated areas, which also overestimated the fractional area of high-risk regions in this study. Accurate assessment of the impact of agricultural activities on the groundwater pollution risk is essential for cultivated areas. Emphasis should be placed on the calculation method of proper parameters for DRASTIC model construction.

Deep borehole heat exchangers (DBHEs) have been widely used for extracting geothermal energy in China. However, the application of this technology in an open well with high temperature remains unknown. In this paper, the thermal performance of a DBHE installed in a groundwater-filled hot dry rock (HDR) well in the Gonghe Basin of Qinghai Province in China was investigated. A U-shaped pipe subjected to a hydraulic pressure of 30 MPa and a temperature of 180 °C was tested successfully. Severe heat loss was detected during the test, which might have been due to the pipe not being well-insulated. To better understand the performance of DBHEs, a numerical model was developed. The results indicate that the pipe’s thermal performance increased by 247% using insulation with a 15 mm layer thickness and a thermal conductivity of 0.042 W/m·K. Thermal performance was significantly improved by increasing the fluid flow rate and pipe diameter. Among the different pipe configurations, double U-shaped buried pipes can achieve the highest performance. The heat-specific rate can reach up to 341.33 W/m with a double U-shaped pipe with a diameter of 63 mm. The second highest rate can be achieved with a coaxial pipe, while single U-shaped pipes have the lowest one.