Experiments on acceleration of electrons and production of X-ray radiation with use of ceramic piezoelectric transformers installed in vacuum are described and analyzed. The piezoelectric transformer operates at resonance frequency. Electrons are accelerated from the high-voltage electrode of the ceramic piezoelectric transformer toward the grounded target, where they emit bremsstrahlung and characteristic X-ray radiation in the target material. The returning of the charge to the high-voltage electrode is provided due to electrons emitted from a filament installed in the vicinity of the target. It was found that the X-ray yield increases linearly at increasing of the pressure of the residual gas in the chamber within two orders of magnitude up to about 10 mTorr, when the gas discharge around of the piezoelectric transformer arises. Possibilities for application of piezoelectric transformers for production of accelerating voltage in small-size accelerators are discussed.
The conception of operation of the pyroelectric accelerator and X-ray source in pulsed mode is at first proposed and demonstrated experimentally. The pulsed mode became possible due to application of the additional controlled source of electrons in the pyroelectric accelerator. In the proof-of-principle experiment, the power of X-ray radiation in pulsed mode increased one in common quasi-continuous mode in more than two orders of magnitude. Perspectives for further increasing of the power and application of pulsed pyroelectric X-ray source in fast X-ray imaging are discussed.
8 December 2024 in International Journal of Mathematical Sciences and Computing
This study analyzes wastewater treatment processes at a mining company in the Almaty region, Kazakhstan. Four treatment schemes were developed and assessed, with a focus on optimizing efficiency. The discharged water quality from different technological lines was evaluated using integral functions for a quantitative comparison of each scheme's performance. Additionally, an expert system was developed to validate the results and support future research in wastewater treatment.
This paper presents the design of a hardware–software system for non-invasive automated monitoring of feeding behavior in livestock with biometric identification of individual animals. Neural network models for animal identification from images and individual recognition have been developed and trained. A solution is proposed to address the challenge of acquiring a sufficient number of personalized animal images for training the identification neural network. A transfer learning approach is introduced for pig identification, where the network is first trained on a large-scale dataset of more than three million human face images obtained from open sources and subsequently fine-tuned by training the upper layers on a significantly smaller dataset consisting of 5610 pig face images. Experimental results demonstrated the high effectiveness of the system: the Top-1 identification accuracy reached 95.1%, while the ROC AUC in open-set recognition tasks achieved 0.95. The processing time per frame on an NVIDIA RTX 4090 GPU was 1.4 ms (724 FPS).
1 December 2021 in Bulletin of the Lebedev Physics Institute
Experimental results on the determination of the end-point bremsstrahlung energy during the operation of a pyroelectric source in vacuum at different resid
The paper presents the dependence of the electric field strength between the crystals of a pyroelectric deflector on their temperature at various rates of temperature change in a vacuum. Three measurement cycles were conducted at different heating rates (0.059∘C/s, 0.015∘C/s, and 0.008∘C/s) followed by subsequent natural cooling. A phenomenon of electric field strength saturation was observed in the temperature range of 40–72∘C during heating and 50–22∘C during cooling of the crystals in the pyroelectric deflector under vacuum conditions. A discrepancy in trends between the extreme states is observed on the graphs of the temperature dependence of the electric field strength in the pyroelectric deflector. The maximum electric field strength between the crystals reaches 40 kV/cm. A tentative explanation is provided for the occurrence of electrical breakdowns between pyroelectric crystals at an electric field strength of 30 kV/cm and a residual gas pressure of 1.5 × 10-5 Torr. The potential application of the pyroelectric deflector in accelerator systems and the prospects for the development of miniature charged particle deflectors are discussed.