The comminution of lignocellulosic biomass is a key operation for many applications as bio-based materials, bio-energy or green chemistry. The grinder used can have a significant impact on the properties of the ground powders, of those of the end-products and on the energy consumption. Since several years, the milling of lignocellulosic biomass has been the subject of numerous studies most often focused on specific materials and/or applications but there is still a lack of generic knowledge about the relation between the histological structure of the raw materials, the milling technologies and the physical and chemical properties of the powders. This review aims to point out the main process parameters and plant raw material properties that influence the milling operation and their consequences on the properties of ground powders and on the energy consumption during the comminution.

Lignocellulosic feedstocks present a growing interest in many industrial processes as they are an ecological alternative to petroleum-based products. Generally, the size of plant raw materials needs to be reduced by milling step(s), to increase density, facilitate transport and storage, and to increase reactivity. However, this unit operation can prove to be important in term of investments, functioning costs, and energy consumption if the process is not fully adapted to the histological structure of the plant material, possibly challenging the profitability of the whole chain of the biomass conversion. In this paper, the different technologies that can be used for the milling of lignocellulosic biomass were reviewed and different avenues are suggested to improve the milling performances thanks to thermal pretreatments. Based on examples on wheat straw milling, the main points to take into consideration in the choice of a milling technologies have been highlighted in regards to the specifications of ground powder. A specific focus on the hazards associated to the milling and the manipulation of fine biomass particles is also realized at the end of the paper from the perspective of industrial applications.

The use of lignocellulosic plant biomass as an alternative to fossil feedstocks for chemistry, energy and materials often involves an intense dry comminution step, for which the energy consumed can vary significantly according to the process parameters, the particle size targeted, and the properties of the biomass. Here we studied the fine milling of maritime pine bark in an impact-mill configuration and in an attrition-mill configuration. The properties of the resulting powders (particle size distribution, particle shape, specific surface area, agglomeration level) obtained in each configuration were compared in relation to process energy consumption. Results evidenced that the agglomeration phenomena drive milling efficiency and limit the possibilities for reaching ultrafine particles. Interestingly, impact loading proved more effective at breaking down coarse particles but tended to generate high agglomeration levels, whereas attrition milling led to less agglomeration and thus to finer particles.

Lignocellulosic biomass represents a readily available reservoir of functional elements that can be an alternative to fossil resources for energy, chemicals and materials production. However, comminution of lignocellulosic biomass into fine particles is required to reveal its functionalities, improve its reactivity and allow practical implementation in the downstream processing steps (carrying, dosage, mixing, formulation, shaping…). The sources of lignocellulosics are diverse, with two main families, being agricultural and forest by-products. Due to plant specificity and natural variability, the itineraries of particle size reduction by dry processing, the behavior upon milling and therefore the characteristics of resulting powders can deeply vary according to various raw biomasses [[1], [2]].