Coupled pressure-driven (viscous) flow and spontaneous imbibition are the main regimes during shale oil production. Revealing the unclear mechanisms of this coupled flow is a major concern for scholars and field engineers. In this work, the oil–water flow mechanisms within shale pore structures are investigated by pore-scale modeling methods in focused ion beam scanning electron microscopy digital rocks enhanced by applying super-resolution reconstruction (SRR). More small pores are identified with SRR, and the connectivity is improved. The enhanced pore size distribution is consistent with the nitrogen adsorption measurement; hence, more representative capillary pressure and relative permeability curves are obtained with essential experimental measurements. Then, an analytical solution of coupled pressure-driven (viscous) flow and spontaneous imbibition is derived, and a corresponding algorithm is proposed. Based on the pore-scale calculated relative permeability and capillary pressure curves, the analytical solution is applied to investigate the variations in water saturation profiles and conductance of the oil phase during the shale reservoir development. The results demonstrate that most of the shale oil is recovered by pressure dropdown-induced viscous flow and that imbibition is a minor factor. The overall oil-relative permeability decreases due to imbibition invasion. When the fracture spacing increases, the impairment of the overall oil-relative permeability decreases.
Optimizing well spacing is crucial for enhancing the production efficiency and economic returns of tight oil development. The limited understanding of hydraulic fracture geometry and properties poses significant challenges in designing well spacing for tight oil reservoirs. In this study, we proposed an integrated workflow for optimizing well spacing in tight oil reservoirs. Geological and geomechanical models were established to form the basis for numerical reservoir simulation and dynamic fracture modeling. A multi-staged, multi-clustered fracture propagation simulation of horizontal wells was conducted by a hydraulic fracturing simulator with matched actual field pumping schedules. The differences between fracture propagation simulation results and field monitoring results, including micro-seismic testing and distributed temperature sensing (DTS) monitoring, were analyzed. The geological model and fracture propagation simulation results were integrated into an efficient numerical reservoir simulator. A material balance method for fracturing fluids leak-off was proposed and utilized to equivalently calculate the actual oil–water distribution after fracturing and to complete the historical matching water cuts of all wells. Subsequently, the inter-well drainage area and pressure interference were evaluated. By employing this integrated workflow, the production performance of six wells (three well pairs) at different well spacings was simulated over a 15-year period, and their estimated ultimate recoveries (EURs) were predicted. When well spacing was less than the optimal distance, oil production dropped significantly. Ultimately, it was determined that reasonable well spacing for this block was 250 m. In future well pattern designs, well spacing smaller than the current value should be used.
27 January 2025 in Geoenergy Science and Engineering