Establishing an accurate vehicle fatigue load spectrum is a critical prerequisite for fatigue life analysis and design of highway bridges. However, the time-varying and regional characteristics of vehicle loads pose significant challenges to achieving this goal. This study focuses on vehicle data collected by a weigh-in-motion system installed on a highway bridge in Chongqing, China. The statistical characteristics of vehicle-load-related parameters are analyzed, and the actual vehicle fatigue load spectrum for this section of the road is established. Specifically, vehicles are first categorized based on axle count characteristics. Then, statistical analyses are conducted on key parameters such as vehicle weight, headway time, and axle load for each vehicle type. Finally, the actual vehicle fatigue load spectrum is developed based on Miner’s linear damage rule and the equivalent fatigue damage principle, and the contributions of different vehicle types to fatigue damage are investigated. The results show that the weight distributions of different vehicle types follow a Gaussian mixture distribution, while the headway time distribution for each lane follows a log-normal distribution. A linear approximate relationship was observed between the axle loads of different vehicle types and their respective total weights. Although two-axle trucks exhibited higher frequencies, six-axle trucks contributed the most to structural fatigue damage, accounting for 53.81%. Therefore, six-axle trucks can be regarded as the standard fatigue vehicle model for this section of the road. These findings provide valuable insights for fatigue design and fatigue life assessment of highway bridges under similar vehicle loading conditions.

Bridges play a key and controlling role in transportation systems. Steel bridges are favored for their high strength, good seismic performance, and convenient construction. As important node connectors of steel bridges, high-strength bolts are extremely susceptible to damage such as corrosion and loosening. Therefore, accurate identification of bolt loosening is crucial. First, a new type of adhesive piezoelectric sensor is designed and prepared using PMN-PT piezoelectric single-crystal materials. The PMN-PT sensor and polyvinylidene fluoride (PVDF) sensor are subjected to steel plate fixed frequency load and swept frequency load tests to test the performance of the two sensors. Then, a steel plate component connected by high-strength bolts is designed. By applying exciter square wave load to the structure, the vibration response characteristics of the structure are analyzed to identify the loosening of the bolts. In addition, a piezoelectric smart washer sensor is designed to make up for the shortcomings of the adhesive piezoelectric sensor, and the effectiveness of the piezoelectric smart washer sensor is verified. Finally, a bolt loosening index is proposed to quantitatively evaluate the looseness of the bolt. The results show that the sensitivity of the PMN-PT sensor is 21 times that of the PVDF sensor. Compared with the peak stress change, the natural frequency change is used to identify the bolt loosening more effectively. Piezoelectric smart washer sensor and bolt loosening indicator can be used for bolt loosening identification.

Suspension bridges, as a type of long-span bridge, usually have a larger longitudinal displacement at the end of the beam (LDBD). LDBD can be used to evaluate the safety of bridge components at the end of the beam. However, due to factors such as sensor failure and system maintenance, LDBD in the bridge health monitoring system is often missing. Therefore, this study reconstructs the missing part of LDBD based on the long short-term memory network (LSTM) and various data. Specifically, first, the monitoring data that may be related to LDBD in a suspension bridge is analyzed, and the temperature and beam end rotation angle data (RDBD) at representative locations are selected. Then, the temperature data at different places of the bridge are used as the input of the LSTM model to compare and analyze the prediction effect of LDBD. Next, RDBD is used as the input of the LSTM model to observe the prediction effect of LDBD. Finally, temperature and RDBD are used as the input of the LSTM model to observe whether the prediction effect of the LSTM model is improved. The results show that compared with other parts of the bridge, the prediction effect of the temperature inside the box girder in the main span as the model input is better; when RDBD is used as the input of the LSTM model, it is better than the prediction effect of temperature as the model input; temperature and RDBD have higher prediction accuracy when used as the input of the LSTM model together than when used separately as the input of the LSTM model.