Dynamic three-dimensional electrode system treatment cyanide wastewater used coal-based electrode as cathode and anode, activated carbon as particle electrodes, the effects of applied voltage, reaction time and flow rate on ion removal rate were studied. SEM-EDS and XPS were used to study the morphology of coal-based electrode and the composition and existing state of the load substances, and the reaction mechanism were analyzed and discussed. The results show that the removal rates of CNT, Cu, Zn, CN-, SCN- in cyanide wastewater were 97.03%, 95.79%, 99.82%, 99.42% and 94.19% respectively when the applied voltage of 4V, the electrode distance of 10mm, the flow rate of 30ml/min, the reaction time of 2.5h and the dosage of activated carbon particles of 2g. The applied voltage is the key factor affecting of ions removal. When the voltage of 2V, the ion removal is mainly due to the synergistic effect of chemisorption and electrosorption. The CN-, SCN- and metal cyanide complex anions in wastewater migrate to the anode of coal-based anode and particle electrode rapidly under the combined action of electric field and magnetic stirring. On the surface of porous coal-based electrode, the removal of CN-, SCN- were mainly attributed to the oxidation of oxygen evolution from the anode reaction, while the removal of Cu, Zn and other metal ions were mainly by the electrodeposition process on the cathode surface.
6 January 2019 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
In this study, the co-pyrolysis of low-rank pulverized coal (SJC) and direct liquefaction residue (DCLR) was comparatively examined. The structure and composition of tar and the evolution characteristics of gas during pyrolysis were analyzed through GC-MS, TG-FTIR, and other analytic techniques. Results showed that SJC+DCLR co-pyrolysis exhibited a significant synergistic effect. SJC and DCLR served as hydrogen donors to facilitate the hydrogenation of small molecular free radical fragments through pyrolysis, which increased the tar yield by 5.55%. Aromatic hydrocarbon and phenol contents in tar decreased by 11.88% and 7.94%, respectively, and alkane content increased by 12.25%. H2 content in gas decreased by 19.05%, and CH4 content increased by 19.60%. Co-pyrolysis could be divided into three stages. In the first stage, adsorbed water and CO2 were removed at room temperature to 344.91°C, and the weak chemical bond between SJC and DCLR began to break. In the second stage, SJC and DCLR became pyrolyzed, small molecular free radical fragments were hydrogenated, large amounts of tar and small-molecule gases were produced at 344.91–643.35°C, and synergistic effect was primarily observed. In the third stage, condensation reaction occurred between small molecular free radical fragments at 643.35–845.75°C, thereby producing solid coke and a small amount of gas.