Atmospheric aerosols influence Earth’s radiative balance, having both warming and cooling effects. Though many aerosols reflect radiation, carbonaceous aerosols such as black carbon and certain organic carbon species known as brown carbon have the potential to warm the atmosphere by absorbing light. Black carbon absorbs light over the entire solar spectrum whereas brown carbon absorbs near-UV wavelengths and, to a lesser extent, visible light. In developing countries, such as India, where combustion sources are prolific, the influence of brown carbon on absorption may be significant. In order to better characterize brown carbon, we present experimental and modeled absorption properties of submicron aerosols measured in an urban Indian city (Kanpur). Brown carbon here is found to be fivefold more absorbing at 365 nm wavelength compared to previous studies. Results suggest ~30% of total absorption in Kanpur is attributed to brown carbon, with primary organic aerosols contributing more than secondary organics. We report the spectral brown carbon refractive indices along with an experimentally constrained estimate of the influence of aerosol mixing state on absorption. We conclude that brown carbon in Kanpur is highly absorbing in nature and that the mixing state plays an important role in light absorption from volatile species.
Emissions from trash burning represent an important component of regional air quality, especially in countries such as India where the practice of roadside, residential, and municipal trash burning is highly prevalent. However, research on trash emissions is limited due to difficulties associated with measuring a source that varies widely in composition and burning characteristics. To investigate trash burning in India, a collaborative program was formed among RTI, Duke University, and the India Institute of Technology (IIT) in Gandhinagar, involving both senior researchers and students. In addition to researching emission measurement techniques, this program aimed to foster international partnerships and provide students with a hands-on educational experience, culminating in a pilot study in India. Before traveling, students from Duke and IIT met virtually to design experiments. IIT students were able to visit proposed sites and offer specified knowledge on burning practices prior to the pilot study, allowing potential experiments to be iteratively improved. The results demonstrated a proof of concept of using a low-cost sensor attached to a commercial drone to measure emissions from a municipal dump site. In addition, for small-scale residential and roadside trash burning, a combustor was designed to burn trash in a consistent way. Results suggested that thermocouples and low-cost sensors may offer an affordable way for combustor designers to assess particulate emissions during prototype iterations. More experiences like this should be made available so that future research can benefit from the unique insights that come from having veteran researchers work with students and from forming international partnerships.
Light-duty trucks (LDTs) are often used to tow trailers. Towing increases the load on the engine, and this additional load can affect exhaust emissions. Although heavy-duty towing impacts are widely studied, data on LDT towing impacts is sparse. In this study, portable emissions measurement systems (PEMSs) were used to measure in-use emissions from three common LDTs during towing and non-towing operations. Emission rates were characterized by operating modes defined in the Environmental Protection Agency’s (EPA’s) MOVES (MOtor Vehicle Emissions Simulator) model. The measured emission rates were compared to the default rates used by MOVES, revealing similar overall trends. However, discrepancies between measured rates and MOVES predictions, especially at high speed and high operating modes, indicate a need for refinement in emissions modeling for LDTs under towing operations. Results highlight a general trend of increased CO2, CO, HC, and NOx when towing a trailer compared to non-towing operations across nearly all operating modes, with distinct CO and HC increases in the higher operating modes. Although emissions were observed to be notably higher in a handful of scenarios, results also indicate that three similar LDTs can have distinctly different emission profiles.