Nickel-based superalloys are widely used in aerospace and other fields due to their excellent properties. In this study, the aging treatment and tensile tests of a GH4169 alloy were carried out. The effects of the δ phase on the alloy’s mechanical properties and fracture behavior were studied. The results showed that the appearance of the δ phase changed from a short rod shape to a needle shape with an increase in aging time. The precipitation method changed from a single mode of precipitation along the grain boundary to two modes of precipitation along the grain boundary and direct precipitation inside the grain. The yield strength and ultimate tensile strength of the alloy first increased and then decreased with an increase in aging time and were related with the microstructure of the δ phase. The similar Widmanstatten structure was not conducive to the mechanical properties of the alloy. The distribution of the δ phase led to the generation of inhomogeneous strain and limited the surface roughening during plastic deformation. The voids initiated at the interface between the δ phase and the matrix γ phase or directly from the δ phase fracture site.

Nickel-based superalloys have become key materials for turbine disks and other aerospace components due to their excellent mechanical properties at high temperatures. Mechanical properties of nickel-based superalloys are closely related to their microstructures. Various heat treatment processes were conducted to obtain the desired microstructures of a nickel-based superalloy in this study. The effect of the initial microstructures on the tensile deformation and fracture behaviors was investigated via in situ digital image correlation (DIC) and synchrotron radiation X-ray tomography (SRXT). The results showed that the size and volume fraction of γ″ and γ′ phases increased with the aging time. The yield strength and the ultimate tensile strength increased due to the precipitation strengthening at the expense of ductility. The surface strain analysis showed severely inhomogeneous deformation. The local strains at the edge of specimens were corresponded to higher void densities. The fracture of carbides occurred owing to the stress concentration, which was caused by the dislocation accumulation. The fracture mode was dimple coalescence ductile fracture.

The performance of clad foils in microforming deserves to be studied extensively, where the strain rate sensitivity of the clad foil concerning the forming performance is a crucial factor. In this paper, the strain rate sensitivity of the mechanical properties of coarse-grained (CG) Cu/Ni clad foils in the quasi-static strain rate range ($\dot{\epsilon }={10}^{-4} {\mathrm{s}}^{-1}~{10}^{-1}{\mathrm{s}}^{-1}$) is explored by uniaxial tensile tests under different strain rates. The results show that the strength and ductility increase with strain rate, and the strain rate sensitivity m value is in the range of 0.012~0.015, which is three times the value of m for CG pure Cu. The fracture morphology shows that slip bands with different directions are entangled in localized areas near the interface layer. Molecular dynamics simulations demonstrate the formation of many edged dislocations at the Cu/Ni clad foils interface due to a mismatch interface. The improved ductility and strain rate sensitivity is attributed to the interaction and plugging of the edged dislocations with high density in the interface layer. Additionally, the influence of size effect on mechanical properties is consistently present in the quasi-static strain rate range. This paper helps to understand the strain rate sensitivity of CG clad foils and to develop clad foils in microforming processes.