The rational design of interfacial contacts plays a decisive role in improving interfacial carrier transfer and separation in heterojunction photocatalysts. In Z-scheme photocatalysts, the recombination of photogenerated electron–hole pairs is prevented so that the redox capacity is maintained. Here, one-dimensional graphitic carbon nitride (g-C₃N₄)/CoFe₂O₄ fibres were synthesised as a new type of magnetic Z-scheme visible-light photocatalyst. Compared with pure g-C₃N₄ and CoFe₂O₄, the prepared composite photocatalysts showed considerably improved performance for the photooxidative degradation of tetracycline and methylene blue. In particular, the photodegradation efficiency of the g-C₃N₄/CoFe₂O₄ fibres for methylene blue was approximately two and seven times those of g-C₃N₄ and CoFe₂O₄, respectively. The formation mechanism of the Z-scheme heterojunctions in the g-C₃N₄/CoFe₂O₄ fibres was investigated using photocurrent spectroscopy and electrochemical impedance spectroscopy. We proposed that one of the reasons for the improved photodegradation performance is that the charge transport path in one-dimensional materials enables efficient photoelectron and hole transfer. Furthermore, the internal electric field of the prepared Z-scheme photocatalyst enhanced visible-light absorption, which provided a barrier for photoelectron–hole pair recombination.

When testing the output of piezoelectric devices under different pressures, the friction between the pressure platform and the device causes a large amount of frictional electrical signals to be mixed in the output piezoelectric signal, seriously affecting the measurement accuracy of the piezoelectric signal. The current solution is to encapsulate the contact interface with identical materials to suppress triboelectric interference. However, this work has shown that even when contact separation is implemented at the interface of same media, triboelectric signals can still be generated. The heterogeneous potential distribution of the same material in contact separation has been discovered for the first time through the contact interface potential distribution, proving that charge transfer still exists between the same materials. Atomic force microscopy (AFM) was used to analyze the microstructure of the interface, and it was found that the existence of the surface tip structure would enhance the electron loss. Based on this, a new electron transfer model for surface–tip electron cloud interaction is proposed in this work. In addition, by comparing the output voltage characteristics of the triboelectric nanogenerators (TENGs) of seven polymer materials (e.g., polypropylene (PP), polyethylene (PE), polyvinyl chloride (PVC), polytetrafluoroethylene (PTFE), polyoxymethylene (POM), polyimide (PI), and polyethylene terephthalate (PET)), it was found that the open circuit voltage of PP material was only 0.06 V when they friction with each other, which is 2–3 orders of magnitude lower than other materials. When PP materials are applied to the package of piezoelectric devices, the precision of piezoelectric output characterization can be improved significantly, and a new experimental basis for a triboelectric theory system can be provided.