In this paper, we propose a modified model which takes the variation of leaf orientation in zenithal space into consideration. It is special because of the linkage between the parameterization of leaf inclination angle and polarized reflectance modelling. The modified model is compared to the Rondeaux-Herman model, the Nadal-Bréon model and a one-parametric linear model using remotely sensed polarized data which was obtained by the Research Scanning Polarimeter (RSP) over Oklahoma on 16 September 2005. The comparison suggests the modified model accurately captures the polarized reflectance of dense vegetation and works more precisely than the other models.
The dynamic response of pump valve motion directly influences the volumetric efficiency of drilling pumps and serves as a critical factor in performance enhancement. This study presents a coupled fluid–structure interaction (FSI) analysis of a novel secondary cushioned pump valve for drilling systems. A validated 3D transient numerical model, integrating piston–valve kinematic coupling and clearance threshold modeling, was developed to resolve the dynamic interactions between reciprocating mechanisms and turbulent flow fields. The methodology addresses critical limitations in conventional valve closure simulations by incorporating a geometrically adaptive mesh refinement strategy while maintaining computational stability. Transient velocity profiles confirm complete sealing integrity with near-zero leakage (<0.01 m/s), while a 39.3 MPa inter-pipeline pressure differential induces 16% higher jet velocities in suction valves compared to discharge counterparts. The secondary cushioned valve design reduces closure hysteresis by 22%, enhancing volumetric efficiency under rated conditions. Parametric studies reveal structural dominance, with increases in cylindrical spring stiffness lowering discharge valve lift by 7.2% and velocity amplitude by 2.74%, while wave spring optimization (24% stiffness enhancement) eliminates pressure decay and reduces perturbations by 90%. Operational sensitivity analysis demonstrates stroke frequency as a critical failure determinant: elevating speed from 90 to 120 rpm amplifies suction valve peak velocity by 59.87% and initial closing shock by 129.07%. Transient flow simulations validate configuration-dependent performance, showing 6.3 ± 0.1% flow rate deviations from theoretical predictions (Qt_max = 40.0316 kg/s) due to kinematic hysteresis. This study establishes spring parameter modulation as a key strategy for balancing flow stability and mitigating cushioning-induced oscillations. These findings provide actionable insights for optimizing high-pressure pump systems through hysteresis control and parametric adaptation.
This study addresses the impact-induced failure of drilling pump valves caused by uncontrolled disc–seat collisions by proposing a novel valve design incorporating a two-stage buffering mechanism. The design employs a wave spring as the primary buffer and an elastic sealing ring as the secondary buffer, effectively mitigating impact through staged energy dissipation. A nonlinear stiffness model of the wave spring, accounting for the transition between line and surface contact modes, was developed. Strong fluid–structure interaction transients were simulated using dynamic meshing and user-defined functions. A parametric study was conducted by systematically varying cylindrical spring stiffness (7.7–15 N/mm), preload (110–160 N), and wave spring type (D85 to D110). Results show that, compared to a conventional valve, the two-stage mechanism reduces impact velocity by 24.2%, accelerates opening response by 17.9%, and extends the closing phase by 0.28%. Increasing wave spring stiffness (from D85 to D110) decreases opening delay time by 98.7% and attenuates peak velocity by 44.4%. Optimized hybrid spring parameters can minimize closing delay height by 27.3%. By reducing seat erosion and suppressing vibration-induced failure, the two-stage buffering mechanism effectively extends valve service life and enhances operational reliability in high-cycle drilling operations.