Fe3O4/H2O nanofluid attracts many researchers’ attention due to its considerable potential for practical applications. This work is focused on the study of heat transfer efficiency in Fe3O4/H2O nanofluids with nanoparticles (NPs) of mean diameter dNPs in the nanosized range (13–50 nm) at volume fractions up to 2%. The Rayleigh–Bénard problem of free convection between plane-parallel plates corresponding to Rayleigh numbers 103–107 is numerically solved. It was shown that the addition of up to 2% of NPs with a diameter of 13 nm can increase the Prandtl number by up to 60% compared to pure water. A map of flow regimes is constructed, indicating the emerging convective patterns. It is demonstrated that as the volume fraction of NPs increases, the Prandtl number grows and the transition to more chaotic patterns with Rayleigh number slows down. It is observed that at a Rayleigh number of 104, the heat flux through the nanofluid layer decreases by up to 25% relative to pure water. Conversely, at Ra ≈ 105, the heat flux through the nanofluid layer increases by up to 18% when using a 2% volume fraction of 13 nm diameter NPs.
The relationship between sp2/sp3-hybridizations ratio of atomic bonds in diamond-like carbon ( DLC --- Diamond-Like Carbon) and its electrical resistivity for coatings with a thickness in the range 22-70 nm prepared by vacuum arc deposition on silicon substrate of the KDB-8 brand has been established. It is established, that an increase in the coating thickness from 22 to 70 nm is accompanied by a decrease in the specific transverse electrical resistance of samples from 17 to 2 GΩ·m. This effect is explained by an increase in the proportion of carbon atoms with sp2-hybridization of electronic orbitals from 86 to 91%, which leads to the appearance of an additional number of π-bonds. A mathematical model, describing the spatial distribution of current when measuring transverse I-V characteristic, has been developed. The results obtained will be useful in creating resistive layers on the electrodes of gas-discharge detectors of charged particle to limit the amount of current in the event of rare spark discharges inside them caused by the registration of random highly ionizing particles. Keywords: ( DLC), electrical properties of thin films, hybridization of electronic orbitals, Raman scattering, I-V characteristic.
1 February 2025 in Physics of Particles and Nuclei Letters
In this paper, an approach to the analysis of hydraulic characteristics for the cooling and thermal stabilization systems of subdetectors in the MPD setup is described, including mathematical modeling and bench tests. Distributed and discrete models are used to simulate the cooling fluid flow. For bench tests, an automated test bench representing a software–hardware complex with vacuum and circulation pumps and liquid pressure, liquid flow rate, and temperature sensors has been developed. The test bench design may be transformed in compliance with formulated test problems. It has been experimentally established that, at a nominal cooling fluid flow rate of 0.006 kg/s, the pressure drop on one cooling pipeline of ADC64ECal modules is ≈0.12 atm. Numerical calculation and experimental measurement results for the pressure drop agree with each other with a deviation less than 2%. The transition to the leakless mode (absolute pressure, 0.4–0.0 atm) does not change the pressure–flow rate characteristic of the ECal panel when compared to the regime of flow at a superatmospheric pressure. The proposed approach is applicable to a broad spectrum of problems on the characterization and commissioning of the thermal stabilization and cooling system of the ТРС detector and other MPD setup detectors.
The relationship between sp2/sp3 hybridizations ratio of atomic bonds in diamond-like carbon (DLC) and its electrical resistivity for coatings with a thickness in the range 22–70 nm prepared by vacuum arc deposition on silicon substrate of the SHB-8 brand has been established. It is established, that an increase in the coating thickness from 22 to 70 nm is accompanied by a decrease in the specific transverse electrical resistance of samples from 17 to 2 GΩ m. This effect is explained by an increase in the proportion of carbon atoms with sp2 hybridization of electronic orbitals from 86 to 91%, which leads to the appearance of an additional number of π-bonds. A mathematical model describing the spatial distribution of current when measuring the transverse I–V characteristic, has been developed. The results obtained will be useful in creating resistive layers on the electrodes of gas-discharge detectors of charged particle to limit the amount of c-urrent in the event of rare spark discharges inside them caused by the registration of random highly ionizing pa-rticles.