The electrochemical behavior of stainless steel and titanium alloys is affected after prolonged contact with basic or acidic solutions, indicating a change in their surface properties. The human body often rejects invasive devices that aim to alter the biological or chemical composition of blood or other body fluids. Stents, fixation plates and screws, spinal implant devices, aneurysm clips, intramedullary nails and stems, temporary fixation devices and surgical instruments, etc. have been made from stainless steel AISI 316L for several years. Although the mechanical performance of implants and devices may be governed by their bulk properties, their interaction with the environment is managed by the characteristics of their superficial layer. In the case of biomedical devices, resistance to corrosion and biocompatibility has paramount importance. This study compares the corrosion behavior of 316L stainless steel and a titanium alloy in a Hank solution. The obtained results show that the titanium alloy has a higher potential than 316L stainless steel and lower corrosion current.
In this paper, the effect of corrosion on the performance of the bonded composite patch repair in aluminum alloy A5083 marine structure was investigated using three dimensional finite element methods. To this end, two patches made in carbon/epoxy and boron/epoxy, bonded on corroded plates with and without crack, were tested under different applied loads. The effect of both corrosion and cracked materials on the damage of the adhesive FM73, was also highlighted. The obtained results show that, the corrosion has a significant effect on the quality repair performance. Indeed, it is proved that, the rate of damage increases with the increase of the applied load, and is more significant in the case of plates cracked and repaired by carbon/epoxy patch. Hence, the best performances were obtained using boron/epoxy patches
31 March 2020 in Fracture and Structural Integrity
High Pressure Torsion (HPT) is a highly effective super-plastic deformation process for obtaining nano-materials with high performance mechanical properties. In view of its optimization, it is of paramount importance to evaluate the relations between the behavior of the material under the effects of different processing parameters. In this context, this work aims to highlight the plastic strain distribution in the deformed material as a function of the hydrostatic pressure, the torsion angle and the temperature of the material applied during the process. A typical amorphous polymer (Polymethyl-Methacrylate: PMMA) has been tested. Firstly, in order to identify the material parameters of a phenomenological elasto-viscoplastic model compression tests at different temperatures and strain rates have been carried out. Then, the distributions of the effective plastic strain, the equivalent plastic strain rate and the hydrostatic stress were analyzed using finite elements method. Recommendations on process conditions were proclaimed at the end of this work according to the obtained numerical results.