Raman spectroscopy, synchrotron angle-dispersive X-ray diffraction (ADXRD), first-principles calculations, and electrical resistivity measurements were carried out under high pressure to investigate the structural stability and electrical transport properties of metavanadate MgV2O6. The results have revealed the coordination change of vanadium ions (from 5+1 to 6) at around 4 GPa. In addition, a pressure-induced structure transformation from the C2/m phase to the C2 phase in MgV2O6 was detected above 20 GPa, and both phases coexisted up to the highest pressure. This structural phase transition was induced by the enhanced distortions of MgO6 octahedra and VO6 octahedra under high pressure. Furthermore, the electrical resistivity decreased with pressure but exhibited different slope for these two phases, indicating that the pressure-induced structural phase transitions of MgV2O6 was also accompanied by the obvious changes in its electrical transport behavior.
11 September 2019 in Environmental Science & Technology
Recently, Ag2Te was experimentally confirmed to be a 3D topological insulator (TI) at ambient pressure. However, the high-pressure behaviors and properties of Ag2Te were rarely reported. Here, a pressure-induced electronic topological transition (ETT) is firstly found in Ag2Te at 1.8 GPa. Before ETT, the positive pressure coefficient of bulk band-gap, which is firstly found in TIs family, is found by both first-principle calculations and in situ high-pressure resistivity measurements. The electrical resistivity obtained at room temperature shows a maximum at 1.8 GPa, which is nearly 3.3 times to that at ambient pressure. This result indicates that the best bulk insulating character and topological nature in Ag2Te can be obtained at this pressure. Furthermore, the high-pressure structural behavior of Ag2Te has been investigated by in situ high-pressure synchrotron powder X-ray diffraction technique up to 33.0 GPa. The accurate pressure-induced phase transition sequence is firstly determined as P21/c → Cmca → Pnma. It is worth noting that the reported isostructural P21/c phase is not existed and the reported structure of Cmca phase is corrected by CALYPSO methodology. The second high-pressure structure, a long puzzle to previous reports, is determined as Pnma phase. A pressure-induced metallization in Ag2Te is confirmed by the results of temperature-dependent resistivity measurements.