A new antenna scattering theory based on characteristic modes (AST-CM) is proposed to analyze the antenna scattering mechanism and guide the design of antenna scattering reduction in this paper. A specific set of modal electric fields, which of an antenna loaded with a short circuit, is used to express the structure mode and antenna mode scattering fields of the antenna with arbitrary loads. The contribution of each characteristic mode to the structure mode and antenna mode scattering fields can be clearly analyzed, which efficiently guides the antenna scattering reduction under the incident plane waves with arbitrary propagation direction and polarization. A typical microstrip antenna is given as an example to validate the proposed AST-CM. The radar cross section (RCS) of the microstrip antenna calculated by AST-CM agrees well with the result simulated by commercial simulation software Altair FEKO. Moreover, the design procedure based on AST-CM is used to guide the in-band RCS reduction of the microstrip antenna under both x - and y -polarized normally incident plane waves. Compared with the reference antenna, the proposed antenna achieves a notable RCS reduction in its operation band with the radiation performance well preserved. The proposed low-RCS antenna is fabricated and measured, and the experimental results are in good agreement with the numerical simulated results.
2 February 2021 in Microwave and Optical Technology Letters
Physical deformation due to service loads seriously degrades the electromagnetic performance of active phased array antennas. However, traditional displacement-based compensation methods are moderately difficult to use because displacement measurements generally require stable references, which are hard to realize for antennas in service. For deformed antennas, strain information is directly related to their displacement, and strain sensors can overcome carrier platform constraints to measure real-time strain without affecting the antenna radiation-field distribution. We thus present a compensation method based on strain information for in-service antennas. First, the minimum number of strain sensors is determined as the main modal-order-based modal effective mass fraction. According to the modal method and analysis of spatial phase-distribution errors related to strain, a coupled strain-electromagnetic model is established to evaluate antenna performance from the measured strain. The corresponding excitation phase from the measured strain is adjusted to compensate antenna performance. Finally, the method is experimentally validated using an X-band active phased array antenna under the influence of typical deformation conditions for both boresight and scanned beams. The results demonstrate that the presented method can effectively compensate for the performance of service antennas directly from the measured strain information.
An optimal design method of elliptical beam Cassegrain antenna based on differential evolution with global and local neighborhoods algorithm is proposed to achieve high efficiency, low sidelobe, and low profile at Ku/Ka dual band. A rapid shaping method of elliptical beam antenna is given by applying the algorithm of steepest descent. Constraining of the first sidelobe level, antenna efficiency is optimized with only 17 variables, where aperture field distribution functions in the major and minor axis planes are parameterized by Non-uniform rational B-spline curves, and the transition function is expressed with a sinusoidal function. A prototype of optimized antenna with an aperture of 630mm $\times1150$ mm is fabricated and measured. The measured results show that the total efficiency is greater than 54.5%, and the first sidelobe levels are lower than −14.2dB across the Ku/Ka dual-band, which agree well with simulated ones. It is verified that the optimal design method is very effective.
In this letter, a design method for low radar cross section (RCS) array antennas based on characteristic mode cancellation (CMC) is presented. Based on the characteristic mode theory (CMT), two novel microstrip elements are designed by introducing rectangular slots and cross slots, which produce 180° scattering phase difference by adjusting the size of slots. The dominant characteristic modes of the two elements achieve broadband dual-linear polarization CMC and similar radiation performances. The 4 × 4 array antenna consisting of these two antenna elements is designed. The operating band is from 4.55 GHz to 5.49 GHz (relative bandwidth 18.7%). The gain loss of the proposed array is about 0.1 dB compared to the reference array. The monostatic RCS is reduced for dual−linear polarized waves, and the 6 dB radar cross section reduction (RCSR) bandwidths are 62.3% and 35.7%, respectively. The prototype is fabricated and measured. The measured results of radiation pattern and RCS are in good agreement with the simulated results.
1 January 2024 in Astronomical Techniques and Instruments
The Tianma 65 m radio telescope (TMRT) at Shanghai is a fully steerable single-dish radio telescope in China, operating at centimeter to millimeter wavelengths (1.25 GHz to 50 GHz). This paper presents details on the main specifications, design, performance analysis, testing, and construction of the telescope antenna. The measured total efficiency is better than 50% over the whole elevation angle range, first sidelobe levels are less than-20 dB, antenna system noise temperatures are less than 70 K at 30° elevation angle, and pointing accuracy is less than 3 ″. The measured and calculated results are in good agreement, verifying the effectiveness of the design and analysis.