The construction of high embankments on soft ground faces several challenges, such as potential bearing capacity failure, global slope instability, local failure, large total and/or differential settlements, and large lateral movement during both construction and post-construction periods. Horizontal geosynthetic reinforcement combined with vertical reinforcement using piles or pile walls can provide an economical and effective solution to ground improvement to support high embankments. This paper reports the results of a numerical study on the performance of embankments on soft ground with three different reinforcement conditions: (1) unreinforced, (2) reinforced with geosynthetics, (3) reinforced with both geosynthetics and pile walls. The influencing factors, such as the tensile stiffness of the geosynthetic, the number of geosynthetic layers, the elastic modulus of the pile wall, and the pile wall distance ratio, on the interaction of geosynthetic-pile wall-soil systems were investigated and the distribution and dissipation of excess pore water pressure in the soil were examined. The numerical results show that a combination of geosynthetic reinforcement and the pile walls was very effective for the improvement of soft ground. The numerical results were shown to be in good agreement with the field data observed at the end of consolidation.
1 June 2010 in Journal of Performance of Constructed Facilities
Concrete culverts in trenches have been widely used in expressways. Problems frequently take place because of improperly estimated vertical earth pressures on culverts. Different codes have been used in China to estimate the design load on culverts. In this study, a full-scale experiment and FEM simulation were conducted to evaluate the variation of vertical earth pressures and soil arching in backfill and to examine the accuracy of the methods recommended by different design codes including the prevailing Chinese General Code for Design of Highway Bridges and Culverts based on the linear earth pressure theory. The measured vertical earth pressures from the experiment were compared with those from the current theoretical methods. The variations of foundation pressure and settlement were also analyzed. The FEM simulation investigated the key influencing factors on the vertical earth pressures including the height of the embankment fill, the width of the trench, the slope angle of the trench, the dimensions...
13 January 2009 in Frontiers of Architecture and Civil Engineering in China
Setting an expandable polystyrene (EPS) board on box culverts can reduce the vertical earth pressure (VEP) acting on the culvert roof. However, long-term backfill load will induce creep in both the EPS board and the surrounding soil, resulting in a change in the stress state of the culvert–soil system. A mechanical model for the long-term interaction of “backfill–EPS board–box culvert” was established, and theoretical formulas were derived for calculating the earth pressure around the culvert. Numerical simulation was employed to validate the accuracy of the proposed theoretical approach. Research indicates that, with EPS board, the VEP decreases rapidly then slightly increases with time and eventually approaches an asymptotic value, ultimately decreasing by 33%. However, the horizontal earth pressure (HEP) shows the opposite pattern and ultimately increases by 15%. The foundation contact pressure (FCP) increases nonlinearly and reaches a stable value, ultimately increasing by 10.2%. Without the EPS board, the VEP and HEP are significantly different from those with the EPS board. Although EPS boards can reduce the VEP on the culvert, attention should be paid to the variation of HEP caused by the creep of the EPS board and backfill.
Culvert-soil interaction and soil arch effect in fill are extremely complicated for box culvert installed in trench terrain. This paper conducted numerous model tests to investigate the load transfer law, earth pressure distribution and variation law of culvert-soil system under different slope angles and trench width for box culverts with/without expandable polystyrene (EPS) board load-reduction, as well as soil arch effect and its change characteristics. Research results indicate that, with EPS board load-reduction, the vertical earth pressure on the culvert top reduces obviously, while the vertical earth pressure at both sides of the culvert increase. The soil arch effect occurs in trench terrain, which transfers the vertical earth pressure from the culvert top to the slope, and its strength is closely related to the backfill height, the trench width and the slope angle. When the trench width is approximately 2 times the width of the culvert and the slope angle is 60°, the EPS load-reduction material will destroy the original soil arch, the load reduction effect is ineffective, the EPS load-reduction measures have minimal impact on the vertical earth pressure at the middle height of the side wall in trench terrain, which significantly different from the embankment installation culvert.
8 March 2009 in Frontiers of Architecture and Civil Engineering in China