Due to the excellent heat transfer performance and low pressure drop, the parallel-plate regenerator (PPR) is very suitable for use in Stirling engines. At present, researches on the application of PPR in Stirling engines are rare. The axial heat conduction loss in PPR is a key factor that affects the heat transfer performance. Therefore, in this paper, the theoretical model of PPR operated under the Stirling engine working conditions is studied numerically, the regenerative effectiveness is taken as the target parameter, and the influence of axial heat conduction and other important parameters are explored. The results show that the axial heat conduction is detrimental to regenerative effectiveness, the regenerative effectiveness does not vary monotonically with the increase in the thermal conductivity, the copper regenerator with higher thermal conductivity has a lower regenerative effectiveness because of its higher axial thermal conductivity. The working frequency and the thermal properties of the working fluids have a comprehensive effect on the regenerative effectiveness, for high thermal diffusivity working fluids, such as helium and hydrogen, the regenerative effectiveness is high, while for low thermal diffusivity working fluid, such as carbon dioxide, the regenerative effectiveness is relatively low, and does not vary monotonously with frequency. The regenerative effectiveness increases with the reduction of the plate spacing, the plate spacing should be determined by considering the regenerative effectiveness and the pressure drop comprehensively. It is recommended that the stainless steel be a suitable material for the plates, and helium be the suitable working fluid.
Amid the global transition toward sustainable energy, regional power grids with high wind power penetration are increasingly emerging. The implementation of frequency control is critically essential for enhancing the frequency support capability of grid-connected devices. However, existing studies indicate this may induce ULFOs (ultra-low frequency oscillations). Current research on ULFOs have been predominantly concentrated on hydro-dominated power systems, with limited exploration into systems where thermal power serves as synchronous sources—let alone elucidation of the underlying mechanisms. This study focuses on regional power grids where wind and thermal power generation coexist. Eigenvalue analysis reveals that frequency regulation control of doubly-fed induction generators (DFIGs) can trigger ULFOs. Leveraging common-mode oscillation theory, an extended system frequency response (ESFR) model incorporating DFIG frequency control is formulated and rigorously validated across a range of operational scenarios. Moreover, frequency-domain analysis uncovers the mechanism by which inertia control affects ULFO behavior, and time-domain simulations are conducted to validate the influence of DFIG control parameters on ULFOs.