Yvonne Theiner

Dr. Yvonne Theiner


Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 May 2014 in Structural Concrete
Verified
Journal Article
Closed access
PDF file
YTYvonne Theiner
Yvonne Theiner
AAAss.-Prof. Andreas Andreatta
Ass.-Prof. Andreas Andreatta
GHGünter Hofstetter
Günter Hofstetter

12 June 2018 in Materials
Verified
Journal Article
Open access
PDF file
MDMartin Drexel
Martin Drexel
YTYvonne Theiner
Yvonne Theiner
GHGuenter Hofstetter
Guenter Hofstetter
The present contribution deals with the experimental investigation of the time-dependent behavior of a typical overlay concrete subjected to tensile stresses. The latter develop in concrete overlays, which are placed on existing concrete structures as a strengthening measure, due to the shrinkage of the young overlay concrete, which is restrained by the substrate concrete. Since the tensile stresses are reduced by creep, creep in tension is investigated on sealed and unsealed specimens, loaded at different concrete ages. The creep tests as well as the companion shrinkage tests are performed in a climatic chamber at constant temperature and constant relative humidity. Since shrinkage depends on the change of moisture content, the evolution of the mass water content is determined at the center of each specimen by means of an electrolytic resistivity-based system. Together with the experimental results for compressive creep from a previous study, a consistent set of time-dependent material data, determined for the same composition of the concrete mixture and on identical specimens, is now available. It consists of the hygral and mechanical properties, creep and shrinkage strains for both sealed and drying conditions, the respective compliance functions, and the mass water contents in sealed and unsealed, loaded and load-free specimens.

1 August 2012 in Journal of Pipeline Systems Engineering and Practice
Verified
Journal Article
Closed access
YTYvonne Theiner
Yvonne Theiner
HLHermann Lehar
Hermann Lehar
GHGünter Hofstetter
Günter Hofstetter
For pipelines laid in difficult ground, as frequently encountered in Alpine regions, a pipe system, consisting of individual pipes made of ductile cast iron, which are connected at joints at the construction site, is a favorable type of construction. This paper deals with the development of such pipelines for high operating pressures. Because the joints have to sustain both the high operating pressure and high axial forces assuring concurrently water tightness, they are the critical parts of such pipe systems. The synthesis of numerical simulations and experimental validation is presented as an efficient design approach. Prototypes are produced on the basis of the results of fully three-dimensional and simpler axisymmetric finite-element simulations. The prototypes are subjected to ultimate load tests for validating the design. A comparison of measured and computed data illustrates the structural behavior of the joint up to the ultimate load.


1 December 2008 in Proceedings in Applied Mathematics and Mechanics
Verified
Journal Article
Open access
PDF file
YTYvonne Theiner
Yvonne Theiner
GHG. Hofstetter
G. Hofstetter
In this contribution the combination of a smeared rotating crack model with a crack model based on the strong discontinuity approach and formulated within the framework of elements with embedded discontinuities is presented. This so–called crack model with delayed embedded discontinuities allows considering crack opening in the direction normal to the crack and relative tangential displacements of the crack faces with transfer of shear forces across the crack faces. The advantages of this approach are shown by the numerical simulation of an anchor pull out test. (© 2008 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)