Light detection and ranging (LIDAR) is an active remote sensing system. Lidar echo signal is non-linear and non-stationary, which is often accompanied by various noises. In order to filter out the noise and extract valid signal information, a suitable method should be chosen for noise reduction. Some denoising methods are commonly used, such as the wavelet transform (WT), the empirical mode decomposition (EMD), the variational mode decomposition (VMD), and their improved algorithms. In this paper, a new denoising method named the WT-VMD joint algorithm based on the sparrow search algorithm (SSA), for lidar signal is selected by comparative experiment analysis. It is shown that this method is the most suitable one with the maximum signal-to-noise ratio (SNR), the minimum root-mean-square error (RMSE), and a relatively small indicator of smoothness when it is used in three kinds (50, 100, and 1000 pulses) of simulate lidar signals. The SNR is increased by 138.5%, 77.8% and 42.8% and the RMSE is decreased by 81.8%, 72.0% and 68.8% when being used to the three kinds of cumulative signal without pollution. Then, the SNR is increased by 83.3%, 60.4% and 24.0% and the RMSE is decreased by 70.8%, 66.0% and 50.5% when being used to the three kinds of cumulative signal with aerosol and clouds. The WT-VMD joint algorithm based on SSA is used in the denoising process for the actual lidar signal, showing extraordinary denoising effect and will improve the inversion accuracy of the lidar signal.

This paper investigates the transmitter and receiver performance of an active rotating tropospheric stratospheric Doppler wind Lidar. A 532 nm laser was determined as the detection wavelength based on transmission and scattering aspects. A ten-fold Galileo beam expander consisting of spherical and aspherical mirrors was designed and produced to compress the outgoing laser’s divergence angle using ZEMAX simulation optimization and optical-mechanical mounting means. The structure and support of the 800 mm Cassegrain telescope was redesigned. Additionally, the structure of the receiver was optimized, and the size was reduced. Meanwhile, the detectors and fiber mountings were changed to improve the stability of the received optical path. A single-channel atmospheric echo signal test was used to select the best-performing photomultiplier tube (PMT). Finally, the atmospheric wind field detection results of the original and upgraded systems were compared. The results show that after optimizing the transmitter and receiver, the detection altitude of the system is increased to about 47 km, and the wind speed and wind direction profiles match better with radiosonde measurements.

Through the observation of ground-based LIDAR and satellite sensors, the weather conditions of continuous foggy-hazy alternations in the Huainan region from 26 December 2016 to 5 January 2017 were analyzed and observed. In this study, the formation and influence of this event were discussed by analyzing pollutant concentrations, meteorological factors and aerosol optical characteristics. The concentrations of PM₁₀ and PM_2.5 increased significantly. The maximum value of PM₁₀ was 412 μg/m³, and the maximum value of PM_2.5 was 258 μg/m³. The transportation of pollutants and the production of man-made pollutants promote the accumulation of pollutants. In this weather process, meteorological factors such as the surface wind speed, humidity, surface temperature, and inversion also promote the accumulation of pollutants, which is the main reason for the formation of this weather process. Furthermore, the near surface air mass mainly came from the cities near the Huainan region and the heavily polluted areas in the north, while the upper air mass came from Inner Mongolia. In this paper, piecewise inversion was adopted to achieve accurate all-weather extinction coefficient profile inversion by reasonably selecting a cloud LIDAR ratio through a backscatter ratio, and the LIDAR ratio of cloud in this period was 22.57–34.14 Sr. By means of extinction coefficient inversion and correlation analysis, the correlation index of PM_2.5 and the aerosol optical depth (AOD) was 0.7368, indicating that there was a positive correlation between PM_2.5 and AOD, and AOD can also reflect the pollution condition of this region. The formation process of foggy-hazy weather in the Huainan region studied in this paper can provide a research basis for foggy-hazy pollution in this region.

A Doppler lidar mounted on a rotary platform has been developed for measuring wind fields in the upper troposphere and stratosphere. The rotating platform was used to support a large system for the detection of wind velocities of sight (VOS) in four directions. The principle, structure, and parameters of the lidar system are introduced. The Fabry-Perot interferometer (FPI), the core component of the wind measurement system, was designed after comprehensively considering the measurement uncertainty and the influence of Mie scattering. Its dual-edge channel bandwidth is 1.05 GHz with 3.48 GHz spacing. In operation, the FPI channels are locked to the laser frequency with a stability of 14.8 MHz. Compared with the local radiosonde, it was found that the deviation in wind speed below 28 km was generally less than 10 m/s, and the deviation in wind direction below 19 km was less than 10 degrees. The 42-day profile comparison between lidar in Hefei and radiosondes in Anqing and Fuyang was analyzed. The statistical results show that the wind speed and wind direction deviations between lidar and radiosondes below 20 km were approximately 10 m/s and 20 degrees, respectively, which are comparable to the regional differences in the wind field. However, as altitudes exceed 20 km, the deviations increased rapidly with height. The experiments indicate that the Doppler lidar could measure wind fields from 7 km to 30 km, with better detection accuracy below 20 km.

In the study of atmospheric wind fields from the upper troposphere to the stratosphere (10 km to 50 km), direct detection wind LiDAR is considered a promising method that offers high-precision atmospheric wind field data. In 2020, Xie et al. of the Anhui Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, developed an innovative rotating Rayleigh Doppler wind LiDAR (RRDWL). The system aims to achieve single-LiDAR detection of atmospheric wind fields by rotating the entire device cabin. In 2022, the feasibility of the system was successfully validated in laboratory conditions, and field deployment was completed. Due to the structural differences between this system and traditional direct-detection wind LiDAR, performance tests were conducted to evaluate its continuous detection capability in outdoor environments. Subsequently, based on the test results and error analysis, further analysis was carried out to identify the main factors affecting the system’s detection performance. Finally, the error analysis and traceability of the detection results were conducted, and corresponding measures were discussed to provide a theoretical foundation for optimizing the performance of RRDWL.

To provide references for the design of the lab’s upcoming prototype of the compact spaceborne lidar with a high-repetition-rate laser (CSLHRL), in this paper, the detection signal of spaceborne lidar was simulated by the measured signal of ground-based lidar, and then, the detection capability of spaceborne lidar under different atmospheric conditions was evaluated by means of the signal-to-noise ratio (SNR), volume depolarization ratio (VDR) and attenuated color ratio (ACR). Firstly, the Fernald method was used to invert the optical parameters of cloud and aerosol with the measured signal of ground-based lidar. Secondly, the effective signal of the spaceborne lidar was simulated according to the known atmospheric optical parameters and the parameters of the spaceborne lidar system. Finally, by changing the cumulative laser pulse number and atmospheric conditions, a simulation was carried out to further evaluate the detection performance of the spaceborne lidar, and some suggestions for the development of the system are given. The experimental results showed that the cloud layer and aerosol layer with an extinction coefficient above 0.3 km⁻¹ could be easily obtained when the laser cumulative pulse number was 1000 and the vertical resolution was 15 m at night; the identification of moderate pollution aerosols and thick clouds could be easily identified in the daytime when the laser cumulative pulse number was 10,000 and the vertical resolution was 120 m.