The aging of bituminous binders is a complex process that is influenced by a number of environmental factors including temperature, sunlight, humidity and reactive oxygen species (ROS) found in the troposphere. The effect of two of these factors, humidity and reactive oxygen species (ROS), are investigated in an environmental aging setup called the Viennese Binder Aging (VBA) method. Three unmodified and one polymer modified binder (PmB) were aged under conditions of varying duration (2 and 3 days), water exposure modes (direct versus indirect) and humidity levels. Additionally, experiments were conducted without the incorporation of ROS. Fourier transform infrared (FTIR) spectroscopy and Dynamic Shear Rheometer (DSR) were used for analysis. One binder showed accelerated aging due to the combination of ROS and humidity. Furthermore, a marginal increase in polybutadiene degradation due to humidity was detectable. However, when ROS were removed from the test setup, increasing the humidity levels did not increase the aging of any of the binders. The fact that the synergistic effects of humidity and ROS only affected the aging of one of the binders shows the complexity of this matter and highlights the importance of incorporating environmental factors into laboratory aging.
8 November 2024 in Transportation Research Record: Journal of the Transportation Research Board
Urban heat islands (UHI) have become an increasingly pressing issue owing to the global warming trend and a steady growth of urban areas. Revegetation, shading, or the reduction of sealed surfaces is not always possible in cities. Therefore, one way to fight UHIs is through adapting currently used pavements. This study assesses the thermal behavior of 12 different pavement materials in a custom-made test stand. The materials include mastic asphalt ( MA 8 , MA 8 white ), porous asphalt ( PA 4 , PA 4 abraded , PA 4 white , PA 8 , PA 8 abraded , PA 8 white ), asphalt concrete ( AC 11 transparent , AC 8 yellow ), and semi-flexible pavements ( SFP 8 , SFP 8 zeolite ). The albedo was assessed using pyranometer. Sensors and thermal imaging were used to measure temperatures during two simulated heat cycles. Both the temperatures underneath the test specimens and at the surface were considered, as well as the cooling times of the materials. The results showed high maximum temperatures for PA and MA , as well as low maxima for the white painted materials, with differences in maxima of up to 15°C. Porous asphalt, like PA 8 , cools faster than MA 8 from roughly 47°C to 28°C, taking 3.7 h compared with MA 8’s 5.1 h. This highlights the importance of considering cooling times and regional solar phases in experimental setups. Through the wide range of tested materials, a significant linear correlation between the measured albedo and surface temperature was proven. Ultimately, a foundation for thermal comparability between these materials was established.
26 February 2026 in Construction and Building Materials
Attenuated Total Reflectance Fourier-Transform Infrared (ATR-FTIR) spectroscopy is widely used to characterise the ageing and modification of bitumen because of the molecular information it provides, its high signal-to-noise ratio, minimal sample preparation, and applicability to solid materials. However, interpretation of ATR-FTIR spectra remains challenging, particularly regarding baseline shifts observed during ageing or modification, which are not well understood yet. To tackle this issue, this study demonstrates that these baseline variations originate from changes in the real part of the refractive index of bitumen, which directly influence the penetration depth of the evanescent wave in ATR-FTIR measurements. By combining ATR-FTIR spectroscopy with ellipsometry, microscopy, and SARA fractionation, a quantitative relationship between refractive index evolution and spectral baseline behaviour was established for different binder sources, ageing states, polymer modifications, and filler additions. Using IR ellipsometry the refractive indices of the saturates, aromatics, resins, and asphaltenes (SARA fractions) were determined, and the changes in fractional composition affecting the bulk refractive index of bitumen was related to aliphatic band vibrations measured with FTIR.Based on these findings, a baseline correction model was developed to compensate for refractive-index-induced distortions in ATR-FTIR spectra. The corrected spectra allow extraction of a predicted bulk refractive index as an alternative ageing index, consistent with conventional markers such as carbonyl and sulfoxide band growth. This approach improves the quantitative reliability, comparability, and inter-laboratory consistency of ATR-FTIR-based ageing assessment.
11 November 2026 in Construction and Building Materials