This study investigates the mechanical and fatigue behaviour of friction stir composite joints fabricated from an aluminum alloy (AA6082-T6) and a glass fibre-reinforced polymer (Noryl® GFN2) under different service temperature conditions. The joints were tested under both quasi-static and cyclic loading at three different temperatures (23, 75, and 130 °C). Fracture surfaces were analyzed, and the probabilistic S–N curves were derived using Weibull distribution. Results indicated that increasing the service temperature caused a non-linear decrease in both the quasi-static and fatigue strength of the joints. Compared to room temperature, joints tested at 75 °C and 130 °C showed a 10% and 50% reduction in average tensile strength, respectively. The highest fatigue strength occurred at 23 °C, while the lowest was at 130 °C, in line with the quasi-static results. Fatigue stress-life plots displayed a semi-logarithmic nature, with lives ranging from 102 to 105 cycles for stress amplitudes between 7.7 and 22.2 MPa at 23 °C, 7.2 to 19.8 MPa at 75 °C, and 6.2 to 13.5 MPa at 130 °C. The joints’ failure occurred in the polymeric base material close to joints’ interface, highlighting the critical role of the polymer in limiting joints’ performance, as confirmed by thermal and scanning electron microscopy analyses.
Friction stir-based joining techniques offer a promising route for the integration of highly dissimilar materials into single structures, with potential applications in safety-critical sectors such as hydrogen storage and lightweight mobility systems. Ensuring structural integrity under dynamic loading is crucial for their industrial adoption, particularly given the strong inhomogeneity of metal–polymer interfaces. This study investigates the strain rate sensitivity of lap joints between an AA6082-T6 aluminum alloy, and a glass-fiber-reinforced polymer (Noryl™ GFN2) produced using a friction stir process. Quasi-static and intermediate strain rate (≈3 s−1) tensile tests were performed on the joints, while both base materials were additionally characterized at quasi-static, and intermediate strain rate conditions using a custom accelerated electromechanical testing device. Digital image correlation was employed to monitor deformation. The results reveal that the joints exhibit clear strain rate sensitivity, with ultimate remote stress and bending angle stiffness increasing by approximately 30% and 23%, respectively, from quasi-static to intermediate strain rate loading. Fracture consistently initiated in the polymer, indicating that the joints mechanical performance is limited by the polymeric constituent, although the polymer strain rate hardening impacts the peel/shear mix in the loading scenario of intermediate strain rate loading. Overall, the findings highlight that while friction stir metal–polymer joints benefit from strain rate hardening, their performance envelope remains governed by the polymer base material.