Radiation detectors installed at major ports of entry are a key component of the overall strategy to protect countries from nuclear terrorism. While the goal of deploying these systems is to intercept special nuclear material as it enters the country, no detector system is foolproof. Mobile, distributed sensors have been proposed to detect nuclear materials in transit should portal monitors fail to prevent their entry in the first place. In large metropolitan areas, a mobile distributed sensor network could be deployed using vehicle platforms such as taxis, Ubers, and Lyfts, which are already connected to communications infrastructure. However, performance and coverage that could be achieved using a network of sensors mounted on commercial passenger vehicles has not been established. Here, we evaluate how a mobile sensor network could perform in New York City using a combination of radiation transport and geographic information systems. The geographic information system is used in conjunction with OpenStreetMap data to isolate roads and construct a grid over the streets. Vehicle paths are built using pickup and drop off data from Uber, and from the New York State Department of Transportation. The results show that the time to first detection increases with source velocity, decreases with the number of mobile detectors, and reaches a plateau that depends on the strength of the source.
Simulating nuclear reactor cores at the highest achievable spatial and energy resolution is critical in modeling these systems accurately. Increasing the resolution, however, can dramatically increase the memory and central processing unit time required to run simulations. A convolutional neural network was shown previously to accurately upsample tally results of simulated light water reactor assemblies fueled with fresh, low enriched uranium. Here, we show that a convolutional neural network can be used to upsample tally results in assemblies containing fresh and depleted fuel enriched from 1.6 to 19.9 atom percent. The network was trained using neutron flux tallies from simulations of light water reactor assemblies with a range of fuel and coolant temperatures and a diverse selection of geometries. Accurate predictions of flux tallies are possible even on test assemblies with geometries and burnup levels well outside the range of those present in the training and validation data. The network improves the data density by a factor of 8 over a broad range of light water reactor assemblies while incurring insignificant additional computational cost to a Monte Carlo simulation.
Long-life fast reactors receive considerable attention for their potential of using uranium efficiently, and because they can operate for extended periods without refueling. However, the main obstacle to achieving maximum operating times and fuel burnup is the neutron radiation damage that accumulates in the cladding and structural materials. Simulations of metal-fueled high-burnup fast reactors showed that the damage in these reactors’ cladding material reached 200 displacements per atom (dpa) long before the maximum burnup was achieved. One possibility for overcoming this problem is spectral softening, which would reduce the kinetic energy imparted to reactor materials when neutrons collide with them. In this work, we compared the peak irradiation damage in metal- and oxide-fueled fast reactors with that in equivalent reactors containing beryllium in the fuel and reflectors. We showed that the peak damage to the cladding in a metal-fueled reactor was reduced from 273 dpa to 230 dpa when beryllium was included in the core. In an oxide-fueled reactor, the peak damage to the cladding was reduced from 225 dpa to 203 dpa. All four reactors were operated with a core-average burnup of 112 MWd/kg of initial heavy metal (IHM), without reshuffling or refueling, and contained the same initial actinide mass profiles.