In this study, a 3D reactive flow simulation model is built to simulate the leakage processes though assumed leakage channels. The geochemical reactions are coupled with fluid flow simulation in this model with consideration of reservoir minerals calcite, kaolinite, and anorthite. As an essential trigger for geochemical reactions, changes in pH value are investigated during and after the CO2 injection process. By comparing CO2 migration with/without geochemical reactions, the influence of geochemical processes on CO2 leakage is illustrated. The leakage behaviors through leakage channels with different permeabilities are evaluated. Influence of reservoir temperature on CO2 leakage is also exhibited. Furthermore, the effects of the distance between the injection well and leakage zone on the leakage potential are studied. The results indicate that the geochemical reactions have impact on the leakage processes, which can decrease the leakage level with the presence of geochemical reactions. The region of low pH enlarges with continuous injection of CO2. Hence, monitoring changes in pH can reflect the migration of CO2, which can provide an alert for CO2 leakage. The occurrence of the leakage phenomenon is postponed with increasing the distance between the CO2 injection well and the leakage channel. However, the leakage level tends to be consistent with injecting more CO2. The CO2 leakage risk can be reduced through the leakage channels with lower permeability. With the presence of higher reservoir temperatures, the leakage risk can be improved. These results can provide references for the application of monitoring methods and prediction of CO2 front associated with geochemical processes.
1 February 2019 in Industrial & Engineering Chemistry Research
Air injection has been proven to be an effective improved oil recovery technique for deep and light oil reservoirs with low permeability and poor water injectivity. But the efficiency of air injection in highly heterogeneous reservoirs is low due to poor gas sweeping that may lead to early oxygen breakthrough caused by gas channeling and viscous fingering. Foam can be used to assist air injection to overcome the obstacles of early gas breakthrough and to increase the displacement and sweeping efficiency. In this paper, laser-etched visual microscopic pore models were used as microfluidic devices to study the air-foam flooding process in porous media at reservoir temperature and high pressure. The dynamic behaviors and relevant mechanisms of air-foam flooding were investigated. Typical mechanisms of foam generation in porous media are achieved in different parts of the micromodel, which can be listed as follows: lamella leave-behind, lamella division, and snap off. Analysis on flow states of air foam showed that foams migrate in porous media by bursting and regenerating during the flooding process. It can be observed that the flow mode of foam in porous media is the separate flow of gas and liquid through microscopic displacement experiments, suggesting that foam should not be treated as a homogeneous phase in heterogeneous porous media. The pressing, occupying, and selective blocking effects of foam in porous media exhibited different oil displacement performances with the presence of various pore geometries and networks. Tiny foams also showed stripping and carrying effects on larger oil droplets benefiting from the lipophilicity of foam. Through comprehensive analysis on overall and local oil displacement mechanisms, air-foam injection could enhance the microscopic sweep volume and improve the oil displacement efficiency.