The objective of designing a biocompatible and mechanically stable scaffold for hard tissue regeneration was achieved by fabricating diopside/forsterite composites. Superior mechanical strength, slow degradation, excellent antibacterial activity and good cell viability were attained with the increase in forsterite ratio in the composites whereas apatite deposition ability got enhanced as the diopside content was increased. The variation in the rate of apatite deposition on the surface of composites exhibited different surface topography such as nano-structured interconnected fibrous network and globular morphology. The scaffolds after one-month immersion in a physiological environment exhibited good Young’s modulus and compressive strength. Clear and distinguishable prevention of bacterial growth confirms that composites have the potential to inhibit microbial colony formation of nine different clinical pathogens. The composite containing major diopside content was more effective toward S. aureus while the growth of E. coli was inhibited more by the composite containing a higher ratio of forsterite. The interaction of composites with MG-63 cells showed an enhancement in cell viability as the content of forsterite was increased. MTS assay confirmed the cytocompatibility of samples with negligible toxicity effects.

The evaluation of wear progress of gear tooth flanks made of 16MnCr5 was performed using non-destructive micro-magnetic testing, specifically Barkhausen noise (BN) and incremental permeability (IP). Based on the physical interaction of the microstructure with the magnetic field, the micro-magnetic characterization allowed the analysis of changes of microstructure caused by wear, including phase transformation and development of residual stresses. Due to wide parameter variation and application of bandpass filter frequencies of micro-magnetic signals, it was possible to indicate and separate the main damage mechanisms considering the wear development. It could be shown that the maximum amplitude of BN correlates directly with the profile form deviation and increases with the progress of wear. Surface investigations via optical and scanning electron microscopy indicated strong surface fatigue wear with micro-pitting and micro-cracks, evident in cross-section after 3 × 10⁵ cycles. The result of fatigue on the surface layer was the decrease of residual compression stresses, which was indicated by means of coercivity by BN-analysis. The different topographies of the surfaces, characterized via confocal white light microscopy, were also reflected in maximum BN-amplitude. Using complementary microscopic characterization in the cross-section, a strong correlation between micro-magnetic parameters and microstructure was confirmed and wear progress was characterized in dependence of depth under the wear surface. The phase transformation of retained austenite into martensite according to wear development, measured by means of X-ray diffraction (XRD) and electron backscatter diffraction (EBSD) was also detected by micro-magnetic testing by IP-analysis.