Ultra-high temperature ceramics are the ideal materials for extreme conditions owing to their very high melting points and good thermo-mechanical properties at high temperatures. For these reasons, they are widely known as materials for aerospace applications. This paper presents a comparative spectral characterization of zirconium, hafnium, and tantalum carbides ultra-high temperature ceramics for concentrating solar power applications. Room-temperature reflectance spectra have been measured from the ultraviolet wavelength region to the mid-infrared band. Using these spectral properties, the ceramics were evaluated as sunlight absorbers in receivers for high-temperature thermodynamic solar plants.

Every optical system for sunlight concentration requires following the sun in its movement. The sun tracking method is essentially chosen on the base of collection geometry and optical system configuration. A simple, useful, and original technique to realise sun tracking is proposed. It is based on a double guiding system using two complementary procedures. A passive tracking device performs a preliminary collector orientation. Then an active tracking system realises its fine positioning and adjustments exploiting an optical pointing sensor. The core of this active tracking device is the sun finder. Pointing sensors for fibre-coupled, CPV (Concentrating Photo voltaic), and linear collectors are presented, illustrating in detail the working principle and practical use. All sensors were optically characterised in laboratory, under controlled and reproducible conditions. Some field tests completed the experimentation evaluating the sensors performance in outdoor working conditions.

Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.

The paper describes a methodology, very simple in its application, for measuring surface irregularities of linear parabolic collectors. This technique was principally developed to be applied in cases where it is difficult to use cumbersome instruments and to facilitate logistic management. The instruments to be employed are a digital camera and a grating. If the reflector surface is defective, the image of the grating, reflected on the solar collector, appears distorted. Analyzing the reflected image, we can obtain the local slope of the defective surface. These profilometric tests are useful to identify and monitor the mirror portions under mechanical stress and to estimate the losses caused by the light rays deflected outside the absorber.

An optical configuration for the detection of faults was developed and tested. The optical fourier transformation is the basic working principle of the system. When good fabric passes in front of the optical system the Fourier image, captured by the camera, shows well defined spots corresponding to the spatial frequencies of the tissue. If a defect occurs during production on the loom, the pattern changes significantly and a defect is easily detected in real time. A very simple electronic image processing based on thresholding and binary histograms allows to obtain very encouraging performance for its applicability to the looms. A compact device has been realized and tested in real working conditions on the loom.

Traffic signaling is an emerging field for light-emitting diode (LED) applications. This sustainable power-saving illumination technology can be used in maritime signaling thanks to the recently updated norms, where the possibility to utilize LED sources is explicitly cited, and to the availability of high-power white LEDs that, combined with suitable lenses, permit us to obtain well-collimated beams. This paper describes the optical design of a LED-based lamp that can replace a traditional lamp in an authentic marine lighthouse. This source recombines multiple separated LEDs realizing a quasi-punctual localized source. Advantages can be lower energy consumption, higher efficiency, longer life, fewer faults, slower aging, and minor maintenance costs. The proposed LED source allows us to keep and to utilize the old Fresnel lenses of the lighthouse, which very often have historical value.