Water pollution is a serious problem in the development of society of China. The plasma technology is one of the advanced oxidation technologies which is an efficient method in wastewater treatment. In this paper the degradation mechanism of organic pollutants in water by plasma is suggested, which is the main chemical reactions and physical effects, the different types of discharge and the corresponding reactors have been mentioned, including pulsed discharge plasma reactor, gliding arc discharge reactor and contact glow discharge electrolysis plasma reactor, especially the reactions in dielectric barrier discharge plasma. The plasma combined with another oxidation reaction processes also are reviewed, including catalyst, Ultraviolet radiation and Fenton reaction combined with plasma reactor.
Perfluorooctanoic acid (PFOA) is an artificially synthesized per-fluorinated chemical widely used in industry. It is often released into the environment without treatment and causes pollution in groundwater. In this paper, we employed a strip fountain dielectric barrier discharge (SF-DBD) plasma source to degrade PFOA from the water. The effects of power supply mode, discharge gases, pH, the conductivity of the solution, concentration, etc., on the degradation efficiency were studied. For a 200 mL sample of 75 mg/L PFOA, a 99% degradation efficiency with a 204.5 μg/kJ energy production rate was achieved using an average power of 43 W negative pulse argon plasma for 50 min at atmospheric pressure. The total organic carbon concentration (TOC) decreased by 63% after a 60 min treatment. The SF-DBD proves to be a promising and energy-saving technique to efficiently remove PFOA from water.
Perfluorooctanoic acid (PFOA) is an artificially synthesized perfluorinated chemical widely used in industries. It is often released into the environment without treatment, which causes pollution in groundwater. Recently, we have reported a rapid and efficient removal of PFOA in aqueous solution by using a fountain-strip dielectric barrier discharge reactor (SF-DBD). This design allows for the gaseous–liquid interaction to happen in a large space at atmospheric pressure, so it is a promising method to efficiently remove PFOA from water. Recently, we reported the effects of the process parameters, including power mode, pulse time, sinusoidal wave discharge, the discharge gas, initial concentration, pH, conductivity, and positive and negative discharges, on the efficiency of this method for PFOA degradation. Understanding the reaction mechanism is key to further improve the efficiency of the system. In this work, we reported the decomposition mechanism of the SF-DBD for PFOA degradation. The mass spectrum (MS) showed that PFOA was degraded to perfluoroheptanoic acid, perfluorohexanoic acid, perfluoropentanoic acid, perfluorobutanoic acid, perfluoropropionic acid, and trifluoroacetic acid after the plasma treatment. The optical emission spectroscope (OES) and the radical scavenger experiments indicated that the excited argon atoms and hydroxyl radicals played a major role in PFOA degradation, while the contributions from the solvated electrons (e−aq), superoxide anion radical (·O2−), and singlet oxygen (1O2) were negligible in initiating the cleavage reaction.
2,2′,7,7′-Tetrakis(N,N-di-p-methoxyphenyl-amine)-9,9′-spirobifluorene (spiro-OMeTAD) film currently prevails as hole transport layer (HTL) employed in perovskite solar cells (PSCs). However, the standard preparation method for spin-coated, Lithium bis(trifluoromethylsulfony) imide (LiTFSI)-doped, spiro-OMeTAD HTL depends on a time-consuming and uncontrolled oxidation process to gain desirable electrical conductivity to favor device operation. Our previous work demonstrated that ~10 s oxygen or oxygen containing gas discharge plasma exposure can oxidize spiro-OMeTAD HTL effectively and make PSCs work well. In this communication, hole-only devices are fabricated and in-situ current density-voltage measurements are performed to investigate the change in hole mobility of LiTFSI-doped spiro-OMeTAD films under plasma exposure. The results reveal that hole mobility values can be increased averagely from ~5.0 × 10−5 cm2V−1s−1 to 7.89 × 10−4 cm2V−1s−1 with 7 s O2 plasma exposure, and 9.33 × 10−4 cm2V−1s−1 with 9 s O2/Ar plasma exposure. The effects on the photovoltaic performance of complete PSC devices are examined, and optical emission spectroscopy (OES) is used for a diagnostic to explain the different exposure effects of O2 and O2/Ar plasma. High efficiency, fine controllability and good compatibility with current plasma surface cleaning techniques may make this method an important step towards the future commercialization of photovoltaic technologies employing spiro-OMeTAD hole transport material.
Dielectric barrier discharge (DBD) plasma has been found to uniquely polymerize ribose that is not usually subject to polymerization since molecules that tend to polymerize almost always possess at least a π-bond. The polymer was analyzed via nuclear magnetic resonance (NMR) spectra, matrix-assisted laser desorption ionization time-of-flight (MALDI TOF) mass spectroscopy and Fourier-Transform inferred spectroscopy (FTIR), and it was found that dehydration occurs during polymerization.
29 September 2026 in Plasma Science and Technology
Anticancer drugs have raised widespread concerns due to their environmental toxicity and persistence. In this study, dielectric barrier discharge (DBD) plasma was applied for the anticancer drug capecitabine (CPC) specifically, and the degradation results showed excellent performance. The degradation efficiency of this technology reached 99.5% at 30 min, and the total organic carbon (TOC) removal rate reached 68.0% at 120 min. Combining density functional theory (DFT) calculations with liquid chromatography-mass spectrometry (LC-MS) results, possible degradation pathways were inferred. Toxicity assessments further confirmed the superiority of the DBD technology. The biotoxicity of CPC was assessed using the luminescent bacterium strain T3, and it was found that the EC50 value of untreated CPC solution for the T3 strain was 37.4%, whereas samples treated for only 30 min showed no acute toxicity. Combined with ECOSAR analysis, it was indicated that the toxicity of most degradation products is lower than that of the parent compound. This confirms that DBD plasma is currently a highly effective technology for treating CPC, achieving efficient degradation, high mineralization, and effective detoxification.