Slow-release nitrogen fertilizers enhance crop production and reduce environmental pollution, but their slow nitrogen release may cause insufficient nitrogen supply in the early stages of crop growth. Mixed nitrogen fertilization (MNF), combining slow-release nitrogen fertilizer with urea, is an effective way to increase yield and income and improve nitrogen fertilizer efficiency. This study used urea alone (Urea) and slow-release nitrogen fertilizer alone (C/SRF) as controls and employed meta-analysis and a random forest model to assess MNF effects on crop yield and nitrogen partial factor productivity (PFPN), and to identify key influencing factors. Results showed that compared with urea, MNF increased crop yield by 7.42% and PFPN by 8.20%, with higher improvement rates in Northwest China, regions with an average annual temperature ≤ 20 °C, and elevations of 750–1050 m; in soils with a pH of 5.5–6.5, where 150–240 kg·ha⁻¹ nitrogen with 25–35% content and an 80–100 day release period was applied, and the blending ratio was ≥0.3; and when planting rapeseed, maize, and cotton for 1–2 years. The top three influencing factors were crop type, nitrogen rate, and soil pH. Compared with C/SRF, MNF increased crop yield by 2.44% and had a non-significant increase in PFPN, with higher improvement rates in Northwest China, regions with an average annual temperature ≤ 5 °C, average annual precipitation ≤ 400 mm, and elevations of 300–900 m; in sandy soils with pH > 7.5, where 150–270 kg·ha⁻¹ nitrogen with 25–30% content and a 40–80 day release period was applied, and the blending ratio was 0.4–0.7; and when planting potatoes and rapeseed for 3 years. The top three influencing factors were nitrogen rate, crop type, and average annual precipitation. In conclusion, MNF should comprehensively consider crops, regions, soil, and management. This study provides a scientific basis for optimizing slow-release nitrogen fertilizers and promoting the large-scale application of MNF in farmland.

Agricultural production in Northwest China is widely constrained by residual plastic film pollution, excessive greenhouse gas emissions, and low productivity. Integrating biodegradable film with controlled-release nitrogen fertilizer offers a promising approach to optimize crop management, enhance yield, and improve environmental outcomes. In this study, three planting patterns (conventional flat planting, FP; ridge mulching with biodegradable film, BM; and ridge mulching with conventional plastic film, PM), two nitrogen fertilizer types (urea, U, and controlled-release nitrogen fertilizer, C), and four nitrogen application rates (0, 80, 160, and 240 kg·hm⁻²) were applied to systematically investigate their effects on alfalfa yield and N₂O emissions from grasslands. The results showed that BM and PM increased alfalfa yield by 23.49% and 18.65%, respectively, compared to FP, while C increased yield by 8.46% compared to urea. The highest yield (24.84 t·hm⁻²) was recorded under the BMC2 treatment, which was 97.11% higher than that of FPN0. N₂O emission flux and cumulative emissions increased with nitrogen application rate. Compared with U, C reduced cumulative N₂O emissions and greenhouse gas emission intensity (GHGI) by 23.89% and 25.84%, respectively. Compared to PM, BM reduced cumulative N₂O emissions and GHGI by 11.58% and 20.15%, respectively. Principal component analysis indicated that the combination of ridge mulching with biodegradable film and 160 kg·hm⁻² of C was optimal for simultaneously increasing alfalfa yield and reducing N₂O emissions, making it a suitable planting–fertilization strategy for the Yellow River irrigation district in Gansu and similar ecological regions.

In arid and semi-arid regions, the cultivation of artificial grasslands commonly suffers from low productivity due to insufficient water supply. The rational application of water-retaining agents is an important approach to alleviating production constraints in artificial grasslands facing resource-based water scarcity. This study investigated two types of water-retaining agents [starch-grafted acrylate water-retaining agent (B1) and polyacrylamide water-retaining agent (B2)] and four application rates [0 kg·hm⁻² (CK), 30 kg·hm⁻² (T1), 60 kg·hm⁻² (T2), 90 kg·hm⁻² (T3)], systematically analyzing their effects on the growth, osmotic adjustment substances, antioxidant enzyme activities, and yield of alfalfa. The results showed that alfalfa plant height, stem diameter, leaf area, branch number, soluble sugar (SS), soluble protein (SP), and proline (Pro) all exhibited a decreasing trend with increasing cutting times. The activities of superoxide dismutase (SOD), catalase (CAT), and peroxidase (POD) in alfalfa leaves initially increased and then decreased with increasing application rates of water-retaining agents, while malondialdehyde (MDA) content showed a decreasing trend. Under the B2T2 treatment, both alfalfa yield and water-use efficiency (WUE) reached their highest values, recorded as 4931.97 kg·hm⁻² (2022), 6021.44 kg·hm⁻² (2023) and 2.19 kg·m⁻³ (2022), 2.39 kg·m⁻³ (2023), respectively. Based on the principal component analysis for comprehensive evaluation, the B2T2 treatment (polyacrylamide water-retaining agent applied at 60 kg·hm⁻²) achieved the highest comprehensive score in both years and could synergistically improve alfalfa yield and water-use efficiency. However, its applicability in the Yellow River irrigation region of Gansu Province and similar ecological areas still requires further verification through field trials.

The critical nitrogen dilution curve (CNDC) model enables precise nitrogen management by quantifying the threshold of nitrogen deficiency in crops, thereby enhancing both crop productivity and nitrogen use efficiency. However, its applicability to perennial crops remains unclear. In this study, alfalfa (Medicago sativa L.), a perennial leguminous forage, was used as the model crop. Based on two years of field experiments, CNDC models of aboveground biomass were constructed under two nitrogen fertilizer regimes: urea (0, 80, 160, and 240 kg·ha⁻¹, applied in a 6:2:2 basal-to-topdressing ratio) and controlled-release urea (CRU; 0, 80, 160, and 240 kg·ha⁻¹, applied as a single basal dose). Using these models, the nitrogen nutrition index (NNI) and cumulative nitrogen deficit (N_and) models were developed to diagnose alfalfa nitrogen status, and the optimal nitrogen application rates were determined via regression analysis. The results showed that critical nitrogen concentration and aboveground biomass followed a power function relationship under both fertilizer types. For CRU treatments, parameters a and b were 3.41 and 0.20 (first cut), 3.15 and 0.12 (second cut), and 2.24 and 0.40 (third cut), respectively. For urea treatments, a and b were 3.13 and 0.35 (first cut), 2.21 and 0.16 (second cut), and 1.75 and 0.73 (third cut). The normalized root mean square error (n-RMSE) of the models ranged from 3.1% to 13%, indicating high model reliability. Based on the NNI, N_and, and yield response models, the optimal nitrogen application rates were 175.44~181.71 kg·ha⁻¹ for urea and 145.63~153.46 kg·ha⁻¹ for CRU, corresponding to theoretical maximum yields of 14.76~17.40 t·ha⁻¹ and 16.76~20.66 t·ha⁻¹, respectively. Compared to urea, CRU reduced nitrogen input by 18.41~20.47% while achieving equivalent or higher theoretical yields. This study provides a scientific basis for nitrogen status diagnosis and precision nitrogen application in alfalfa cultivation.

An imbalance between the supply and demand of nutrients within the crop–soil system has resulted from the prevalent practice of excessive fertilization in agricultural agriculture. In order to increase crop growth, improve resource usage efficiency, and reduce agricultural nonpoint source pollution, appropriate cropping management techniques are essential. This study examined the effects of four nitrogen application rates (0 kg·ha⁻¹ (C0), 80 kg·ha⁻¹ (C1), 160 kg·ha⁻¹ (C2), and 240 kg·ha⁻¹ (C3)) and three alfalfa cropping systems (traditional flat planting, FP; ridge-covered biodegradable mulch, JM; and ridge-covered conventional mulch, PM) on soil inorganic nitrogen transport, nitrogen allocation within alfalfa plants, and soil N₂O emissions. Throughout the alfalfa growth phase, the dynamics of nitrogen balance within the soil–plant–atmosphere system were quantitatively examined. The findings showed: (1) The concentrations of soil NO₃⁻–N and NH₄⁺–N rose with the rate of nitrogen application but decreased with soil depth. The PMC3 treatment had the largest inorganic nitrogen reserves at the end of the alfalfa growth period. (2) The pattern of PM > JM > FP for nitrogen uptake and nitrogen accumulation in biomass in alfalfa leaves and stems peaked at the C2 nitrogen treatment rate. (3) As nitrogen application rates increased, grass-land N₂O emission flow and total emissions also followed PM > JM > FP. (4) The PMC2 treatment showed apparent nitrogen balances of 9.73 kg·ha⁻¹ and 1.84 kg·ha⁻¹ during the two-year growing season, with apparent nitrogen loss rates of 6.08% and 1.15%, respectively, both significantly lower than other treatments, according to nitrogen balance analysis. In summary, the nitrogen application pattern combining ridge-covering conventional plastic mulch with moderate nitrogen application levels can achieve nitrogen balance in alfalfa grassland systems within the Yellow River irrigation district of Gansu Province, China, and similar ecological zones.