Bojan Brodic

Dr. Bojan Brodic

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2015 in Journal of Applied Geophysics
Verified
Journal Article
Open access
BBBojan Brodic
Bojan Brodic
AMAlireza Malehmir
Alireza Malehmir
CJChristopher Juhlin
Christopher Juhlin
LDLars Dynesius
Lars Dynesius
MBMehrdad Bastani
Mehrdad Bastani
HPHans Palm
Hans Palm
During the last few decades there has been an increased demand for infrastructure, along with a greater awareness of environmental issues in the construction industry. These factors have contributed to an increased interest in using seismic methods for near surface characterization, particularly in urban environments. Seismic sensors not affected by anthropogenic electromagnetic noise are therefore important, as well as an acquisition system that is easy to deploy, move and non-invasive. To address some of these challenges, a multicomponent broadband MEMS (micro-electro mechanical system) based landstreamer system was developed. The landstreamer system is fully digital, therefore it is less sensitive to electrical or electromagnetic noise. Crosstalk, leakage and tilting tests show that the system is superior to its predecessors. The broadband nature of the sensors (theoretically 0â\u80\u93800 Hz), 3C (three-component) recording and the close spacing of the sensors enable high-resolution imaging. The current streamer configuration consists of 20 sensors 4 m apart and 80 sensors 2 m apart. The streamer can easily be combined with wireless recorders for simultaneous data acquisition. In this study, we present results from testing of the streamer with various sources, such as a shear wave vibrator and different types of impact sources. MEMS-sensors and their high sensitivity allowed recording clear reflections that were not observed with coil-based sensors. A complementary test was also carried out at a planned access ramp for an urban tunnel where potential poor quality rocks had been identified by drilling. First-break traveltime tomography showed that these poor quality rocks correlate with low velocity zones. The presented landstreamer system has great potential for characterizing the subsurface in noisy environments

23 October 2019 in Geophysical Prospecting
Verified
Journal Article
Closed access
PDF file
MPMyrto Papadopoulou
Myrto Papadopoulou
FCFederico Da Col
Federico Da Col
BMBinbin Mi
Binbin Mi
EBEmma Bäckström
Emma Bäckström
PMPaul Marsden
Paul Marsden
LSLaura Valentina Socco
Laura Valentina Socco

6 April 2015 in Geophysical Prospecting
Verified
Journal Article
Closed access
PDF file
AMAlireza Malehmir
Alireza Malehmir
SWShunguo Wang
Shunguo Wang
JLJarkko Lamminen
Jarkko Lamminen
BBBojan Brodic
Bojan Brodic
MBMehrdad Bastani
Mehrdad Bastani
JPJoachim Place
Joachim Place

6 October 2015 in Geophysics
Verified
Journal Article
Closed access
AMAlireza Malehmir
Alireza Malehmir
FZFengjiao Zhang
Fengjiao Zhang
MDMahdieh Dehghannejad
Mahdieh Dehghannejad
ELEmil Lundberg
Emil Lundberg
CDChristin Döse
Christin Döse
HMHenrik Möller
Henrik Möller
We have developed a multicomponent broadband seismic landstreamer system based on digital sensors and particularly suitable for noisy environments and areas in which high-resolution images of the subsurface are desired. We have evaluated results, interpretations, and approaches using the streamer in the planning of an approximately 3-km-long underground tunnel in the city of Varberg in the southwestern Sweden. Prospective targets were imaging of the shallow (<20 m) bedrock surface and weak zones, such as fracture and shear zones. Over the course of three weeks, 25 profiles were acquired with a total length of approximately 7.5 km using a source and receiver spacing of 2–4 m. A novel approach of the data acquisition was to integrate the landstreamer with wireless sensors in areas in which the accessibility was restricted by roads and also to increase the source-receiver distances (offsets). Although the area was highly noisy, the seismic data, in conjunction with available boreholes, successfully led to delineation of the bedrock surface, its undulations, and areas of poor rock quality. To overcome challenges due to geologic complexities and crooked-line data acquisition, 3D tomographic inversion of first breaks was carried out. Comparisons of the results with the existing boreholes indicated that in most places, the bedrock surface was well resolved by the method, which supported the indication of weak zones in the bedrock, represented by low-velocity structures in the tomographic results. We also evaluated the effect of poor geodetic surveying, particularly regarding elevation data, which adulterated the tomography results toward undulating bedrock surfaces or zones of low velocities.

6 April 2016 in Solid Earth
Verified
Journal Article
Open access
PDF file
AMAlireza Malehmir
Alireza Malehmir
MAMagnus Andersson
Magnus Andersson
SMSuman Mehta
Suman Mehta
BBBojan Brodic
Bojan Brodic
RMRaymond Munier
Raymond Munier
BLBjörn Lund
Björn Lund
Glacially induced intraplate faults are conspicuous in Fennoscandia where they reach trace lengths of up to 155 km with estimated magnitudes up to 8 for the associated earthquakes. While they are typically found in northern parts of Fennoscandia, there are a number of published accounts claiming their existence further south and even in northern central Europe. This study focuses on a prominent scarp discovered recently in lidar (light detection and ranging) imagery hypothesized to be from a post-glacial fault and located about 250 km north of Stockholm near the town of Bollnäs. The Bollnäs scarp strikes approximately north–south for about 12 km. The maximum vertical offset in the sediments across the scarp is 4–5 m with the western block being elevated relative to the eastern block. To investigate potential displacement in the bedrock and identify structures in it that are related to the scarp, we conducted a multidisciplinary geophysical investigation that included gravity and magnetic measurements, high-resolution seismics, radio-magnetotellurics (RMT), electrical resistivity tomography (ERT) and ground-penetrating radar (GPR). Results of the investigations suggest a zone of low-velocity and high-conductivity in the bedrock associated with a magnetic lineament that is offset horizontally about 50 m to the west of the scarp. The top of the bedrock is found ∼ 10 m below the surface on the eastern side of the scarp and about ∼ 20 m below on its western side. This difference is due to the different thicknesses of the overlying sediments accounting for the surface topography, while the bedrock surface is likely to be more or less at the same topographic level on both sides of the scarp; else the difference is not resolvable by the methods used. To explain the difference in the sediment covers, we suggest that the Bollnäs scarp is associated with an earlier deformation zone, within a wide (> 150 m), highly fractured, water-bearing zone that became active as a reverse fault after the latest Weichselian deglaciation.

4 August 2021 in Near Surface Geophysics
Verified
Journal Article
Open access
PDF file
SSSilvia Salas‐Romero
Silvia Salas‐Romero
AMAlireza Malehmir
Alireza Malehmir
ISIan Snowball
Ian Snowball
BBBojan Brodic
Bojan Brodic
Quick‐clay landslides are important geohazards in Sweden, Norway and Canada. While they have been studied using various geotechnical and geophysical methods, only a handful of seismic surveys have been reported for their studies. Here, we reprocess active‐source seismic data from a quick‐clay landslide site in southwest Sweden to complement earlier studies of reflection imaging and first‐break traveltime tomography with surface‐wave dispersion analysis. Results suggest extremely low shear‐wave velocities, even as low as 60–100 m/s. From a geotechnical perspective, this implies that the region classifies as a high‐risk zone for landslides and construction purposes. High or anomalous values of Poisson's ratio (or similarly P‐ and S‐wave velocity ratio) depict a zone within the normally consolidated sediments that likely represents a coarse‐grained layer, thus confirming earlier results from a number of boreholes drilled in the study area. Overall, the results presented further support to the previous hypothesis that the coarse‐grained layer plays a major role in the formation and creation of quick‐clay landslides in the study area. Additionally, an attempt to model the distribution of potential quick clays along one of the seismic profiles is performed through a combination of the modelled geophysical properties and soil textures. This study illustrates the potential of seismic methods, and how the integration of multiple geophysical properties and different data handling strategies can help to accurately characterize regions susceptible to quick‐clay landslides.