In this paper, the overall mechanical response of composite laminates with different structural orientations in low-velocity impacts is discussed using a combination of finite element simulations and experiments. In this process, the crack dissipation energy combined with absorbed energy is proposed as the damage index to evaluate the degree of the plate’s impact damage. Both the impact energy and the crack energy calculated from the experimental primary damage energy are verified. The results show that with the increase in the impact energy, the primary damage mode changes, which changes the crack-absorbed energy accordingly as well as the stiffness and load-bearing capacity of the plate structure during the impact process. This index can not only be used to characterize the performance of cracks in the overall damage but can also predict the damage state of the plate and plain weave fabric.
13 November 2023 in Physical Chemistry Chemical Physics
The electronic band structure and magnetic anisotropy in 2D Dirac half-metal MnBr3 can be modulated by external stimuli such as strain, magnetization direction, and interlayer coupling.
2219 aluminum–copper alloy is a major material in launch vehicles transition rings. The study of dynamic recrystallization during its rolling and forming process is beneficial to improving the performance enhancement of 2219 aluminum alloy ring parts. In this paper, a multi-scale simulation of grain refinement and distribution of dynamic recrystallization (DRX) grains during the rolling of 2219 aluminum alloy rings is carried out using the finite element method and cellular automata method. On the basis of the JMK DRX model, an ABAQUS subroutine was written to simulate the ring-rolling of 2219 aluminum alloy, and the distribution of DRX percentage and average grain size was analysed from a macroscopic point of view, with a maximum DRX level of 12% and an average grain size distribution from 247 μm to 235 μm from the inside of the aluminum alloy ring towards the surface. A cellular automaton model of DRX during rolling of large aluminum alloys was developed to effectively simulate DRX nucleation, growth, and grain compression deformation during rolling. The DRX nucleation occurs at the grain boundaries and then grows, resulting in a homogeneous organisation and a refinement of grain size, with both the original and DRX grains being compressively deformed as the rolling process progresses and the grains being gradually elongated tangentially. Finally, a comparison of the experimental results with the simulations to obtain grain size and morphology demonstrates consistent results, indicating that the combination of FE and CA methods is an effective approach for a more comprehensive understanding of the microstructural evolution during rolling.
18 December 2017 in IOP Conference Series: Earth and Environmental Science
A three phase direct coupled interleaved boost converter (TP-DIBC) was recommended in this paper. This converter has a small unbalance current sharing among the branches of TP-DIBC. An adaptive control law sliding mode control (SMC) is designed for the TP-DIBC. The aim is to 1) reduce ripple output voltage, inductor current and regulate output voltage tightly 2) The total current carried by direct coupled interleaved boost converter (DIBC) must be equally shared between different parallel branches. The efficacy and robustness of the proposed TP-DIBC and adaptive SMC is confirmed via computer simulations using Matlab SimPower System Tools. The simulation result is in line with the expectation.