Han Wenbo

Dr. Han Wenbo

Laboratory of Science and Technology for National Defence on Advanced Composites in Special Environments, Harbin Institute of Technology, Harbin 150001, China

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 May 2017 in Scientific Reports
Verified
Journal Article
Open access
PDF file
YCYehong Cheng
Yehong Cheng
SZShanbao Zhou
Shanbao Zhou
PHPing Hu
Ping Hu
GZGuangdong Zhao
Guangdong Zhao
YLYongxia Li
Yongxia Li
Han WenboHan Wenbo
Han Wenbo
Graphene aerogels with high surface areas, ultra-low densities and thermal conductivities have been prepared to exploit their wide applications from pollution adsorption to energy storage, supercapacitor, and thermal insulation. However, the low mechanical properties, poor thermal stability and electric conductivity restrict these aerogels’ applications. In this paper, we prepared mechanically strong graphene aerogels with large BET surface areas, low thermal conductivities, high thermal stability and electric conductivities via hydrothermal reduction and supercritical ethanol drying. Annealing at 1500 °C resulted in slightly increased thermal conductivity and further improvement in mechanical properties, oxidation temperature and electric conductivity of the graphene aerogel. The large BET surface areas, together with strong mechanical properties, low thermal conductivities, high thermal stability and electrical conductivities made these graphene aerogels feasible candidates for use in a number of fields covering from batteries to sensors, electrodes, lightweight conductor and insulation materials.

26 March 2019 in Materials
Verified
Journal Article
Open access
PDF file
LSLei Shang
Lei Shang
YLYang Lyu
Yang Lyu
Han WenboHan Wenbo
Han Wenbo
Tetraethyl orthosilicate was selected as a matrix of heat insulating materials among three silanes, and an anti-infrared radiation fiber was chosen as a reinforcement for silica aerogel insulation composite. The silica aerogel was combined well and evenly distributed in the anti-infrared radiation fiber. The heat insulation effect was improved with the increase in thickness of the aerogel insulation material, as determined by the self-made aerospace insulation material insulation performance test equipment. The 15 mm and 30 mm thick thermal insulation material heated at 250 °C for 3 h, the temperatures at the cold surface were about 80 °C and 60 °C, respectively, and the temperatures at 150 mm above the cold surface were less than 60 °C and 50 °C, respectively. The silica aerogel composites with various thicknesses showed good thermal insulation stability. The silica insulation composite with a thickness of 15 mm exhibited good heat insulation performance, meets the thermal insulation requirements of general equipment compartments under low-temperature and long-term environmental conditions. The thermal conductivity of prepared silica aerogel composite was 0.0191 W·m−1·k−1 at room temperature and 0.0489 W·m−1·k−1 at 500 °C.

2 February 2016 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
GZGuangdong Zhao
Guangdong Zhao
PHPing Hu
Ping Hu
SZShanbao Zhou
Shanbao Zhou
GCGuiqing Chen
Guiqing Chen
YAYumin An
Yumin An
Han WenboHan Wenbo
Han Wenbo

27 October 2021 in Journal of Advanced Ceramics
Verified
Journal Article
Open access
PDF file
YLYang Lyu
Yang Lyu
BDBaihe Du
Baihe Du
GCGuiqing Chen
Guiqing Chen
GZGuangdong Zhao
Guangdong Zhao
YCYuan Cheng
Yuan Cheng
Han WenboHan Wenbo
Han Wenbo
To further improve the oxidation resistance of polymer derived ceramic (PDC) composites in harsh environments, Cf/SiC/SiHfBOC composites were prepared by chemical vapor infiltration (CVI) and precursor impregnation pyrolysis (PIP) methods. The weight retention change, mechanical properties, and microstructure of Cf/SiC/SiHfBOC before and after oxidation in air were studied in details. Microscopic analyses showed that only the interface between the ceramics and fibers was oxidized to some extent, and hafnium had been enriched on the composite surface after oxidizing at different temperature. The main oxidation products of Cf/SiC/SiHfBOC composites were HfO2and HfSiO4after oxidation at 1500 °C for 60 min. Moreover, the weight retention ratio and compressive strength of the Cf/SiC/SiHfBOC composites are 83.97% and 23.88±3.11 MPa, respectively. It indicates that the Cf/SiC/SiHfBOC composites should be promising to be used for a short time in the oxidation environment at 1500 °C.

14 March 2016 in Journal of the American Ceramic Society
Verified
Journal Article
Closed access
PDF file
YCYeHong Cheng
YeHong Cheng
YQYushi Qi
Yushi Qi
PHPing Hu
Ping Hu
SZShanbao Zhou
Shanbao Zhou
GCGuiqing Chen
Guiqing Chen
Han WenboHan Wenbo
Han Wenbo

14 September 2018 in Journal of the American Ceramic Society
Verified
Journal Article
Closed access
PDF file
YCYehong Cheng
Yehong Cheng
YLYang Lyu
Yang Lyu
Han WenboHan Wenbo
Han Wenbo
PHPing Hu
Ping Hu
SZShanbao Zhou
Shanbao Zhou
XZXing-Hong Zhang
Xing-Hong Zhang