Pulsed Laser Ablation in Liquids (PLAL) is a technique for synthesizing high-purity, ligand-free nanomaterials with controlled size and morphology. This study focuses on the synthesis of MXene nanostructures (Ti₃C₂), by using a focused pulsed excimer laser at 193 nm and 2-4 J/cm2 (150 mJ at 5 Hz for 30 minutes). Using a 2 mm thick and 5 mm diameter Ti₃C₂ target in a solvent blend of deionized water and dodecyl sulfate dispersant, producing nanostructured MXenes under transient conditions of ~2,000 K temperature and 10⁷-10⁸ Pa pressure. The method minimizes contamination from precursors and byproducts, offering precise control over nanoparticle size and distribution while preserving structural integrity and functional properties. The synthesized MXenes were characterized using Scanning Electron Microscopy (SEM) and Energy Dispersive Spectroscopy (EDS) and revealed distinct morphologies such as wrinkled sheet-like structures like graphene oxide, uniform nanostructures consistent 2D flakes indicating a controlled synthesis that yields thin, uniform layers WS2, and minimal synthesis damage: low defect density and minimal oxidation observed in EDS spectra. This study demonstrates the viability of PLAL method for producing high-quality MXene nanoparticles and provides a foundation for future innovations in nanomaterial synthesis for a wide range of other 2D technological applications.
Polydimethylsiloxane (PDMS), a silicon-containing polymer, is widely used in flexible electronics, coatings, and polymer-derived ceramics. However, its response to high-intensity pulsed photonic processing under inert and reducing atmospheric environments remains insufficiently understood. Spin-coated PDMS films (~5 μm) were photonically cured using millisecond xenon-flash pulses at fluences up to 4.1 J/cm² and pressures up to 4 atm under argon (Ar), forming gas (5% H₂ in Ar), and vacuum. Fourier-transform infrared spectroscopy (FTIR), energy-dispersive X-ray spectroscopy (EDS), and scanning electron microscopy (SEM) evaluated chemical, compositional, and morphological changes. FTIR revealed reduced methyl-group signatures and siloxane bonding restructuring, particularly under forming gas. EDS indicated Si retention (19 wt% Si at 3 atm and 2.6 J/cm2) and enhanced carbon removal. Ar limited oxygen (O2) incorporation, whereas vacuum produced minor structural changes. SEM revealed relatively smooth film surfaces. The combined observations suggest the formation of disordered Si-rich, O2, and C containing nanostructures (SiOₓCᵧ). Within the investigated pressure range, 3 atm yielded the strongest observed structural transformation under forming gas. These findings demonstrate that atmosphere, pressure, and fluence jointly influence PDMS transformation. To the best of our knowledge, this is the first systematic investigation establishing a scalable, pressure-assisted pulse photonic processing route for PDMS-derived SiOₓCᵧ based nanostructure. Higher fluence, while maintaining 3 atm and improving oxidation control warrant further investigation for potential energy-storage applications.