Background The efficacy of compression therapy depends mainly on the exerted pressure and on the stiffness of the material. Objective To propose a simple method by which pressure and stiffness can be assessed in the individual patient. Material and Methods Using a pressure transducer (Kikuhime small probe, MediTrade, Soro, Denmark) the sub-bandage pressure is measured on the medial aspect of the lower leg at the transition of the gastrocnemius muscle into the Achilles' tendon. The pressure difference between active standing and lying is defined as the static stiffness index (SSI). Results The accuracy and precision of the probe are good. Unna boot bandages (Lohmann-Rauscher, Vienna, Austria) and multilayer short-stretch bandages show a significantly higher SSI than long-stretch bandages and round-knitted class II stockings. The SSI values are lower than 10 mm Hg for elastic, long-stretch material and higher than 10 mm Hg for inelastic, short-stretch material. Conclusion In future compression trials, pressure and stiffness measured in vivo should be declared.
BACKGROUND Compression bandages appear to be simple medical devices. However, there is a lack of agreement over their classification and confusion over the use of important terms such as elastic, inelastic, and stiffness. OBJECTIVES The objectives were to propose terms to describe both simple and complex compression bandage systems and to offer classification based on in vivo measurements of subbandage pressure and stiffness. METHODS A consensus meeting of experts including members from medical professions and from companies producing compression products discussed a proposal that was sent out beforehand and agreed on by the authors after correction. RESULTS Pressure, layers, components, and elastic properties (P‐LA‐C‐E) are the important characteristics of compression bandages. Based on simple in vivo measurements, pressure ranges and elastic properties of different bandage systems can be described. Descriptions of composite bandages should also report the number of layers of bandage material applied to the leg and the components that have been used to create the final bandage system. CONCLUSION Future descriptions of compression bandages should include the subbandage pressure range measured in the medial gaiter area, the number of layers, and a specification of the bandage components and of the elastic property (stiffness) of the final bandage.
BACKGROUND Interface pressure and stiffness characterizing the elastic properties of the material are the deciding parameters determining the dosage of compression treatment and should therefore be measured in future clinical trials. AIM The aim of this consensus paper is to provide some recommendations regarding the use of suitable methods for this indication. METHOD This paper was formulated based on the results of an international consensus meeting between a group of medical experts and representatives from the industry held in January 2005 in Vienna, Austria. RESULTS Proposals are made concerning methods for measuring the interface pressure and for assessing the stiffness of a compression device in an individual patient. CONCLUSIONS In vivo measurement of interface pressure is encouraged when clinical and experimental outcomes of compression treatment are to be evaluated.
The main points in this scholarly review on the use of compression therapy in leg ulcers are the different modes of action of this treatment and the tools that are available including their practical applicability and use for self management. Due to its effect of counteracting gravity, compression is also suggested for ulcers with aetiologies that are not usually thought to require compression. The clinical evidence reported in ulcer-healing studies are discussed and some considerations are made relating to the cost-effectiveness of this management. In general, the failures of compression therapy are not caused by poor compression material but due to poor knowledge and application techniques of the care providers. Future studies comparing different compression devices should also report details concerning the compression material used and the pressure exerted.