Due to high metal prices and increased difficulties in finding shallower deposits, the exploration for and exploitation of mineral resources is expected to move to greater depths. Consequently, seismic methods will become a more important tool to help unravel structures hosting mineral deposits at great depth for mine planning and exploration. These methods also can be used with varying degrees of success to directly target mineral deposits at depth. We review important contributions that have been made in developing these techniques for the mining industry with focus on four main regions: Australia, Europe, Canada, and South Africa. A wide range of case studies are covered, including some that are published in the special issue accompanying this article, from surface to borehole seismic methods, as well as petrophysical data and seismic modeling of mineral deposits. At present, high-resolution 2D surveys mostly are performed in mining areas, but there is a general increasing trend in the use of 3D seismic methods, especially in mature mining camps.

Three-dimensional seismic reflection data from the Halfmile Lake area, New Brunswick, Canada, was reprocessed over an 18- km2 grid to improve the seismic signatures of a 5-million-ton volcanic-hosted massive sulfide (VHMS) deposit located at 1200-m depth, known as the deep zone, as well as key host-rock structures. We chose a prestack dip moveout (DMO) and poststack migration processing sequence to preserve the possible diffraction signature of the deep VHMS zone. Despite the high level of source-generated noise and large statics caused by near-surface conditions, our processing results revealed improved 3D seismic images for shallow and deep structures. Many of the imaged structures were easily correlated with known lithological con-tacts constrained by boreholes and petrophysical measurements. A short, flat-lying segment of high-amplitude reflection at about 800-m depth in the unmigrated cube was interpreted to originate from a small portion of the lower VHMS zone. The DMO stack was characterized by a large, high-amplitude asymmetric diffraction signature originating from the deep VHMS zone. The asymmetry of the diffraction hyperbola relative to the location of the deep zone was interpreted as resulting from a shape effect from the zone, with the strongest amplitudes along the diffraction hyperbola found north-northwest of the apex. This indicated that the deep VHMS zone dips in a similar direction. This diagnostic diffraction signature was not preserved with the prestack migration approach previously implemented for processing Halfmile Lake data.

Summary. We present a joint transmission and reflection traveltime tomography algorithm based on the Fast Sweeping Method and the adjoint-state technique. In c

Multioffset, multiazimuth downhole seismic data were acquired at Halfmile Lake, New Brunswick, to image known massive sulfide lenses and to investigate the potential existence of a steeply dipping mineralized zone connecting them. The massive sulfide lenses, which have significantly higher elastic impedances than host rocks, produce strong scattering. The downhole seismic data show prominent scattered (P-P and S-S) and mode-converted (P-S and S-P) waves originating from the deposit. Such complex scattering from massive sulfide ore was not observed previously in vertical seismic profiling data. Migration of the scattered and mode-converted waves from several shot points imaged different parts of the deepest lens. The scattered S-waves and mode-converted waves provide additional imaging capabilities that should be considered when selecting downhole seismic methods for mining exploration.