Prograde evolution of illite/smectite occurring in an unusually-thick (8000 m) sequence of Mesozoic-Cenozoic sediments in the Basque-Cantabrian Basin, Spain, has been studied using XRD and TEM/AEM. The sediments, which are only slightly tilted, cover the range from smectite to illite, and the most deeply buried ones are unique in that they span the range from diagenesis through low-grade metamorphism (anchizone), with no apparent overprinting due to tectonic deformation.Pelites are absent from the shallow section, but smectite occurs in marls as high-charge, K-dominant and low-charge, K-poor anastomosing arrays of layers. At intermediate depths, authigenic clay is identified largely as R1 I/S, coexisting with packets of R≫3 I/S (nearly pure illite), where illite-like and smectitelike layers can be identified by contrast in TEM images, which is consistent with XRD data. The authigenic clay of the deepest samples consists of illite with no or almost no expandable layers, which occurred as packets with layers largely subparallel to bedding, K-deficient composition in comparison with muscovite, 1Md-like SAED patterns, and 100 Å mean packet thickness. There is no evidence of deformation stress-induced, non-bedding-parallel clays in the deepest samples. Detrital micas with either a phengiterich or a phengite-poor composition range dominate the phyllosilicate fraction of all the samples. Detrital micas show no changes over the diagenesis/metamorphism range and appear to have behaved as if isolated from authigenic clays.Authigenic clays occur as bedding-subparallel packets that evolved during passive burial metamorphism through dissolution/crystallization of less-evolved clays. Where illite-like and smectite-like layers can be identified, TEM images imply a discontinuous series in which packets of R1 I/S (50% I) transform to packets of nearly-pure illite, that is, an Ostwald-step-rule-like sequence. Such immature illite remains unmodified with further burial, and is apparently the potential predecessor of stress-induced, highly-evolved mica of higher-grade, tectonically-deformed pelites.

Low-temperature metamorphic petrology occupies the P–T field between sedimentary and metamorphic petrology. Two important pillars of low-temperature metamorphism are coal petrology and clay mineralogy. When low temperature petrology was established bridging a hiatus between the two classical geological disciplines of sedimentary geology and metamorphic petrology, geologists faced a need for the usage of different terminology tenets. Martin Frey and Bernard Kübler were two pioneers in low-grade metamorphic petrology. They focused their research on clarifying the relationships of clay mineralogy and organic petrology to metamorphic pressure (P) and temperature (T) conditions. The ultimate aim of M. Frey and B. Kübler was to establish a correlation between clay indices and organic parameters for different geodynamic setting and therefore for various pressure–temperature (P–T) conditions occurring in low grade metamorphic terranes. For this purpose, a special attention was addressed to the correlation between the Kübler-Index (KI) and vitrinite reflectance (VR). All these efforts are dedicated to estimate the P–T conditions and thus to gain insight into the geodynamic evolution of low-grade metamorphic terranes. B. Kübler and M. Frey honored here concentrated their studies to the Helvetic Central Alps area. The very low-grade Helvetic domain is therefore of basic interest of this paper. Ensuing the extensive compilation of data from the Helvetic domain, a reinterpretation of Kübler and Frey’s research is presented in the light of last decade’s scientific progress. A comprehensive dataset available enables to discriminate many factors influencing the Kübler-Index and organic-matter reflectance alongside to time, temperature and pressure. The correlation is restricted to the KI and organic matter reflectance (mostly VR) because most of the studies used both methods. Organic matter reflectance (OMR) includes data from vitrinite reflectance and bituminite reflectance measurements. Geodynamics has important control on the KI/VR (OMR) correlation. Tectonic units having a similar geodynamic evolution are featured by the comparable KI/OMR trends, related to the particular paleo-geothermal conditions. Obviously the KI/OMR correlations provide a mean to characterise geothermal gradients and metamorphic very-low-grade pressure–temperature conditions. In terranes where high deformations rates are reported, exceeding the high anchizone conditions, strain promotes the kinetic effects of temperature and pressure on the KI versus OMR ratio.