Nickel-based alloy IN 625 is used to protect components of aircrafts, power generation and oil refinery due to an association of toughness and high corrosion resistance. These properties are associated with the chemical composition and microstructure of coatings which depend on the processing parameters and the composition of the component being protected. This paper assessed impact of dilution on the microstructure and properties of the Ni alloy IN 625 deposited by Plasma Transferred Arc (PTA) on two substrates: carbon steel API 5L and stainless steel AISI 316L. Differences due to the interaction with the substrate were maximized analyzing single layer coatings, processed with three deposition current: 120, 150 and 180 A. Correlation with a cast Nickel-based alloy sample contributed to assess the impact of dilution on coatings. Dilution was determined by the area ratio and Vickers hardness measured on the transverse section of coatings. Scanning electron and Laser confocal microscopy and X-ray diffraction analysis were carried out to characterize the microstructure. Results indicated the increasing dilution with the deposition current was deeply influenced by the substrate. Dilution ranging from 5 to 29% was measured on coatings processed on the API 5L steel and from 22 to 51% on the low thermal conductivity AISI 316L steel substrate. Differences on the microstructure and properties of coatings can be associated with the interaction with each substrate. Higher fraction of carbides account for the higher coating hardness when processing on API 5L whereas the low thermal conductivity of AISI 316L and the higher Fe content in solid solution contributed to the lower hardness of coatings.
1 April 2016 in Materials Science and Engineering: A
This work assessed Ni-based C276 alloy coatings by PTA with different degree of interaction with AISI 316L and API 5L X70 steel substrates. Track geometry, dilution and microstructure of coatings were evaluated by optical, scanning electron microscopy and X-ray diffraction. Properties were evaluated by hardness and wear tests. Microstructure exhibited austenite Ni-FCC dendrites and interdendrictic regions containing carbides. Dilution from 4,9 to 25,4% for coatings on API 5L X70 leaded to hardness ranging from 283 to 243 HV0,5. Otherwise, dilution between 22,3 and 41,5% for coatings on AISI 316L induced hardness from 267 to 225 HV0,5. Higher interaction with the substrate leaded to 19,8% increase of mass loss rate on API 5L X70 coatings. The slight difference for coatings properties deposited on different substrates indicated that the degree of interaction was the most significant factor.