We proposed an all-optical Ka-band microwave long-distance dissemination system based on an optoelectronic oscillator (OEO). In this system, a single tone with high spectrum purity and low phase noise is excited by an injection-locked OEO, and distributed to the remote site through the fiber loop of the OEO at the same time. The second harmonic of the reference signal modulates the round-tripping optical signal at the local site, which achieves the phase conjugator at the optical domain. At the remote end, the phase-conjugated signal is photomixed with the OEO signal to eliminated the phase offset. The proposed scheme improves the phase noise of the high frequency signal received at the remote site and reduces the photoelectric conversion loss. We demonstrated the transmissions of a 36 GHz frequency-quadrupled RF signal along a 6 km optical fiber loop, and the frequency stability is 1.069 × 10 −14 /1 s and 3.3 × 10 −16 /1000 s. The single-sideband (SSB) phase noise of the received signal at the remote site is up to −130 dBc/Hz at 10 kHz offset frequency.
We present a dispersion-independent phase stabilized distribution architecture for broadband signal based on photonic microwave phase conjugation. RoF signals are distributed from the central station to each base station via a fiber ring network. The elimination of dispersion-induced optical phase decorrelation is achieved because the backward transmission of the phase-conjugated signal, thus the EVM of the RoF signal is optimized. A proof-of-concept experiment is demonstrated. A distribution of QPSK modulated 23-GHz, 400M Baud RoF signals from the central station to a remote base station is obtained via a fiber optic loop. The demodulated constellation and error vector magnitude with and without dispersion compensation are measured at the remote base station. When we set the length of the fiber loop to 58km, the EVM is reduced by 8% after dispersion compensation, and the compensated EVM can reach the threshold value of 17.5% specified by 3GPP for 5G when the received optical power of PD is 4dBm.
We propose and demonstrate a self-reconfiguration network of high-precision time-frequency synchronization. The local oscillator (LO) signal and time reference signal generated by the central site are transmitted to the two-fiber unidirectional ring in opposite directions. The all-optical microwave phase conjugation and the time-frequency domain transform measurement are utilized to eliminate phase fluctuation and time delay introduced by optical fiber. The two-fiber unidirectional ring can automatically switch the working loop when the fiber link is broken and avoid manual intervention, which realizes the self-healing of the network. A 20 GHz frequency signal and 1 pulse per second time signal are transferred along a 7 km fiber ring. At 1000 s averaging time, the long-term frequency stability of the order of 10 to 16 and time stability of the order of ps can be achieved at remote sites. When the network is interrupted, the proposed system can automatically recover the time-frequency synchronization from the failure state within 37 ms.
Adaptive digital back-propagation (A-DBP) is a promising candidate for mitigating Kerr nonlinearity due to its ability to estimate the optimal nonlinear scaling factor adaptively. However, the adaptive process relying on the gradient-dependent algorithm is prone to fluctuation, leading to extra iterations or even divergence and resulting in huge computational efforts in A-DBP. In this paper, an improved A-DBP algorithm with long-term memory (LTM) is proposed, employing root mean square propagation (RMSProp) to achieve low-complexity and high-robustness compensation performances. The A-DBP-LTM algorithm based on RMSProp was numerically validated through the simulated transmission of 69 Gbaud DP-16QAM over 2000 km and further verified through an experiment involving 26-λ 63 Gbaud DP-16QAM transmission over 1200 km. Compared with conventional digital back-propagation and A-DBP based on a gradient-descent algorithm, our proposed method allows substantial complexity reductions of 31.35% and 58.47%, respectively. Furthermore, high robustness in only a few iterations and a 0.33 dB improvement in the optical signal–noise ratio penalty were also experimentally demonstrated.
Mode-locking optoelectronic oscillators (OEOs) have emerged as one of the recent research frontiers in the OEO field. In an OEO cavity, the mode-locking of longitudinal modes can be realized through passive mode-locking, active mode-locking, and self-mode-locking. These methods can generate a series of microwave combs with similar intensities or produce microwave pulses. Both passive and active mode-locking demand the incorporation of additional control devices, such as saturable absorbers and microwave sources, into the basic OEO system. This not only complicates the OEO system but also poses challenges for its future applications. We hereby propose a microwave signal generation system based on a long-fiber-cavity self-mode-locking OEO. This system leverages high gain and high nonlinearity to induce mode-locking among the longitudinal modes of the loop, thus generating modulated signals, microwave pulse and microwave frequency comb. By precisely adjusting the loop gain, the mode-locking frequency can be varied, which further varies the modulation frequency of the output signal, the pulse repetition rate and the comb intervals of the microwave frequency comb. This significantly enhances the usability of the system. Moreover, benefiting from the energy storage capacity of the long fiber, the intracavity signal exhibits excellent phase noise performance. Therefore, this system holds great potential for wide-ranging applications in fields such as communication and radar.