Tarek Selmi

Tarek Selmi


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 September 2022 in Environmental Science and Pollution Research
Verified
Journal Article
Closed access
PDF file
TSTarek Selmi
Tarek Selmi
AKAhmed Khadhraoui
Ahmed Khadhraoui
ACAdnen Cherif
Adnen Cherif

1 March 2014
Verified
Conference Paper
Closed access
TSTarek Selmi
Tarek Selmi
MAMohamed Abdul-Niby
Mohamed Abdul-Niby
LDLaura Devis
Laura Devis
ADAndrew Davis
Andrew Davis
In this paper, a mathematical analysis of a photovoltaic cell is presented for the single diode and double diode cell configurations. The model of the double diode representation was implemented using a proprietary algorithm and MATLAB/Simulink. To track the point of maximum power, the perturb and observe (P&O) algorithm method was implemented. It was shown that the point of maximum power is always located at the expected position, is readily tracked, and maintained by minute increases and decreases in voltage. These encouraging results indicate opportunities for the utilization of this algorithm and its hardware implementation.

7 August 2022 in Engineering, Technology & Applied Science Research
Verified
Journal Article
Open access
AKA. Khadhraoui
A. Khadhraoui
TSTarek Selmi
Tarek Selmi
ACA. Cherif
A. Cherif
Electric Vehicles (EVs) are becoming more popular and gaining attention due to a combination of factors such as falling prices and increasing environmental awareness. EVs fall into several categories related to energy production and storage. Standard developed, tested, and commercialized EV technologies include Fuel Cell Electric Vehicles (FCEVs), All Electric Vehicles (AEVs), also known as Battery Electric Vehicles (BEVs), Plug-in Hybrid Electric Vehicles (PHEVs), Hybrid Electric Vehicles (HEVs), and Flexible Fuel Vehicles (FFVs). Still, the advantages of FCEVs are relatively small compared to other autonomous and refueling technologies. Considering the above aspects, this work presents a Matlab/Simulink model of an FCEV’s behavior and opportunities.

2 August 2017 in International Journal of Energy and Environmental Engineering
Verified
Journal Article
Open access
PDF file
TSTarek Selmi
Tarek Selmi
RBRabeb Belghouthi
Rabeb Belghouthi
This paper presents a model of a photovoltaic (PV) cell based on InGaN instead of regular cells made up of silicon, while polarization effects are considered. The model is constructed under Matlab/Simulink environment upon the equivalent electrical circuit of the PV cell. The way components of the equivalent electrical circuit are connected leads to establishing mathematical equations, thus, describing the behavior of the PV cell under different environmental and physical conditions. Once the PV cell model is validated by means of experimental results, it has been extended to build a model of a PV module made up of numerous cells interconnected in diverse potential configurations depending on the expected outputs in terms of current/voltage. The model has shown promising and accurate results and would aid researchers in the field of power electronics to consider it as a truthful PV generator (PVG).

1 November 2015
Verified
Conference Paper
Closed access
TSTarek Selmi
Tarek Selmi
HBHania El-Kanj Baitie
Hania El-Kanj Baitie
AMAhmed Masmoudi
Ahmed Masmoudi
The paper deals with an approach to diagnose and remediate the faults affecting the Hall Effect sensors equipping brushless DC (BLDC) motors. The proposed approach is basically made up of an algorithm capable to detect, identify and remediate the fault in any of the three BLDC motor Hall Effect sensors. Following the detection of the fault, pointed out by a sensors binary word “000” or “111”, the algorithm allows the identification of the faulty sensor. A dedicated procedure is implemented for the sake of reconfiguration of the Hall Effect sensors-based control strategy. Simulation works, carried out under different faulty scenarios, have proven the performances of the proposed approach.

1 December 2018 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Verified
Journal Article
Open access
PDF file
TSTarek Selmi
Tarek Selmi
MRMaher Rezgui
Maher Rezgui
Experiments confirmed that Transformerless Inverters (TIs) deliver more reliability and higher energy efficiency. Nonetheless, one of the shortcomings of TIs is the leakage current that occurs between the photovoltaic (PV) string terminals and the ground. Such a drawback is justified by the non-galvanic isolation caused by the transformer being omitted. As such, this study is intended to develop a novel TI inverter topology for solar PV systems. The latter is meant to remove the leakage current and enhance the operating system of the entire PV conversion as well. Added to its null zero-crossing distortion and capability regarding energy efficiency, the developed TI, being validated by simulation and experiment, eradicated the leakage current.