Kenji Nakamura

Prof. Kenji Nakamura

orcid

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 September 2011 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
MFMichinari Fukuoka
Michinari Fukuoka
KNKenji Nakamura
Kenji Nakamura
OIOsamu Ichinokura
Osamu Ichinokura
Magnetic gears are able to transmit torque without mechanical contact. Therefore, these have attractive features, such as low acoustic noise and maintenance-free operation in comparison with conventional mechanical gears. Planetary-type magnetic gears, especially, have higher transmission torque than the other types, and are expected to be put into practical use. This paper presents a method for calculating dynamic characteristics of the magnetic gear based on reluctance network analysis (RNA). The RNA has several features, including a simple analytical model, high calculation accuracy, and ease of coupled analysis with rotational motion of rotors.

18 October 2012 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
YHYu Hasegawa
Yu Hasegawa
KNKenji Nakamura
Kenji Nakamura
OIOsamu Ichinokura
Osamu Ichinokura
This paper presents a novel switched reluctance (SR) motor that has auxiliary windings and permanent magnets on the stator yoke. It can be driven by an asymmetric half-bridge converter in the same manner as the conventional SR motor, and the performance is improved by the auxiliary windings and magnets. The characteristics of the proposed SR motor are demonstrated by finite element method (FEM) and experiment. In addition, operating principle and characteristics in the case of generating mode are indicated.

20 March 2006 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
KWK. Wasa
K. Wasa
SIS. Ito
S. Ito
KNKenji Nakamura
Kenji Nakamura
TMT. Matsunaga
T. Matsunaga
IKI. Kanno
I. Kanno
DND. Y. Noh
D. Y. Noh
Thin films of single c -domain/single-crystal (1−x)Pb(Mg1∕3Nb2∕3)O3−xPbTiO3 (PMN-PT) with x≅0.33 near a morphotropic boundary composition were heteroepitaxially grown on (110)SRO∕(001)Pt∕(001)MgO substrates. The heteroepitaxial growth was achieved by rf-magnetron sputtering at the substrate temperature of 600°C . After the sputtering deposition, the substrates were rapidly cooled from 600°C to room temperature by atmospheric air gas at a cooling rate of 100°C∕min . The rapid cooling process enhanced the heteroepitaxial growth of the single c -domain/single crystal PMN-PT thin films. Their electromechanical coupling factor kt measured by a resonance spectrum method was 45% at resonant frequency of 1.3GHz with phase velocity of 5500 to 6000m∕s for the film thickness of 2.3μm . The d33 and d31 were 194pC∕N and −104pC∕N , respectively. The observed kt,d33 , and d31 were almost the same to the bulk single-crystal values. The present PMN-PT thin films are applicable for a fabrication of GHz planar bulk acoustic wave transducers.

25 September 2006 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
ATA. Takahashi
A. Takahashi
HGH. Goto
H. Goto
KNKenji Nakamura
Kenji Nakamura
TWT. Watanabe
T. Watanabe
OIO. Ichinokura
O. Ichinokura
This paper describes a consideration of the excitation circuit of a switched reluctance (SR) generator. The SR generator has some features including solid structure and easiness of maintenance. However, the conventional excitation circuit of the SR generator is an asymmetry half bridge converter (AHBC) whose configuration is complicated. In this paper, we examine the operating characteristics of the SR generator excited by a suppression resistor converter (SRC) based on finite-element method (FEM) analysis and experiments

1 April 2005 in Journal of Magnetism and Magnetic Materials
Verified
Journal Article
Closed access
KNKenji Nakamura
Kenji Nakamura
KKKoshiro Kimura
Koshiro Kimura
OIOsamu Ichinokura
Osamu Ichinokura

20 May 2010 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
YHYu Hasegawa
Yu Hasegawa
KNKenji Nakamura
Kenji Nakamura
OIOsamu Ichinokura
Osamu Ichinokura
A switched reluctance (SR) motor has a doubly salient pole structure. A stator has concentrated windings on each pole, while a rotor is only made of iron core. Therefore, the SR motor is expected as a low cost, extremely robust, variable speed motor. The performance of the SR motor greatly depends on magnetic properties of core material since it consists of only laminated-core and windings. This paper investigates the performance of an SR motor made of permendur which has extremely high saturation flux density and very low core loss. Motor torque, iron loss, and efficiency of the SR motor are estimated by finite element method (FEM). Furthermore, a suitable structure for the SR motor made of permendur is examined based on the design of experiments.