While numerous studies have explored the mineralogical characteristics and purification techniques of high-purity quartz (HPQ), discussions on impurity control during various purification processes and their applications in photovoltaics, electronics, and optics remain limited. This review delves into the adverse effects of impurities such as aluminum, iron, and sodium in the manufacturing processes of these industries, emphasizing their critical role as these impurities can degrade material performance. This paper focuses on analyzing the types of impurities found in quartz and evaluates existing purification technologies such as acid washing, ultrasonic acid washing, chlorination roasting, and calcination quenching. It highlights the limitations of current technologies in processing quartz ore and discusses the advantages of different impurity types under various technological treatments. Moreover, it explores the environmental and economic impacts of these high-purity processes, underlining the necessity for more environmentally friendly and cost-effective purification techniques. The purpose of this review is to provide a comprehensive technical and strategic framework for the use of high-purity quartz in high-tech applications, supporting future research and industrial applications in this critical material field.

Waste copper slag is a typical hazardous solid waste containing a variety of valuable elements and has not been effectively disposed of so far. In this paper, a stepwise extraction process was proposed to recover valuable elements (copper, iron, lead and zinc) from waste copper slag. The specific procedures are as follows: (1) A flotation process was adopted to enrich copper, and when the copper grade in the flotation concentrate was 21.50%, the copper recovery rate was 77.78%. (2) The flotation tailings were pelletized with limestone, then the green pellets were reduced, and the magnetic separation process was carried out. When the iron and copper grades in the magnetic concentrate were 90.21% Fe and 0.4% Cu, 91.34% iron and 83.41% copper were recovered, respectively. (3) Non-magnetic tailings were mixed with clinker and standard sand to produce common Portland cement. Several products were obtained from the waste copper slag through the proposed process: flotation concentrate, measured 21.50% Cu; magnetic concentrate, containing 90.21% TFe and 0.4% Cu; direct reduction dust, including 65.17% ZnO and 2.66% PbO; common Portland cement for building construction. The comprehensive utilization method for waste copper slag achieved zero tailing and has great potential for practical application.

In this paper, an innovative method is proposed to upgrade iron and remove phosphorus from high-phosphorus oolitic hematite ore by the sodium magnetization roasting–magnetic separation–sulfuric acid and sodium hydroxide leaching process. The process parameters of sodium magnetization roasting, acid leaching, and alkaline leaching were optimized. The results show that by only adopting traditional magnetization roasting–magnetic separation, an iron ore concentrate containing 57.49% Fe and 1.4% P₂O₅ at an iron recovery rate of 87.5% and a dephosphorization rate of 34.27% was produced, indicating that it is difficult to effectively dephosphorize and upgrade iron by the conventional magnetization roasting–magnetic separation process. The obtained rough magnetic concentrates were then subjected to acid and alkaline leaching steps, and the final product, assayed at 64.11% iron and 0.097% P₂O₅, was manufactured successfully. Moreover, the added NaOH could promote the mineral phase reconstruction of aluminum- and silica-bearing minerals during magnetization roasting and intensify the upgrading of iron as well as enhance the growth of iron grains.