The lift-off flow of the supersonic streamwise vortex in oblique shock-wave/jet interaction (OS/JI), extracted from a wall-mounted ramp injector in the scramjet, is studied through the large-eddy simulation method. The shocked helium jet deforms into a pair of the streamwise vortex with a co-rotating companion vortex. The trajectory of the streamwise vortex center is lifted by the shock interaction. Based on the objective coordinate system in the frame of oblique shock, it is found that the nature of the three-dimensional lift-off structure of the OS/JI is inherently and precisely controlled by the structure kinetics of a corresponding shock bubble interaction (SBI). The striking similarities of both qualitative and quantitative results between the OS/JI and the SBI support the proposition that the lift-off of the streamwise vortex is the result of an underlying two-dimensional vortical motion. By combining the first-stage linear growth mode of Richtmyer–Meshkov instability with the second-stage vortex formation mode, a two-stage vortex propagation model suitable for the SBI is proposed and validated. The lift-off growth of a shocked jet in the OS/JI concerned and in the wall-mounted ramp injector cases from the literature is well explained under the two-stage vortex propagation model of SBI. This model further predicts that increasing ramp compression shows little effect on elevating the streamwise vortex for higher free-stream Mach numbers (Ma > 5). In comparison, evident lift-off may occur for lower Mach numbers (Ma < 3.5), which offers the new way for the preliminary design of a streamwise vortex-based ramp injector in the scramjet.
To investigate the intrinsic mechanism for mixing enhancement by variable-density (VD) behaviour, a canonical VD mixing extracted from a supersonic streamwise vortex protocol, a shock–bubble interaction (SBI), is numerically studied and compared with a counterpart of passive-scalar (PS) mixing. It is meaningful to observe that the maximum concentration decays much faster in a VD SBI than in a PS SBI regardless of the shock Mach number ( $Ma=1.22 - 4$ ). The quasi-Lamb–Oseen-type velocity distribution in the PS SBI is found by analysing the azimuthal velocity that stretches the bubble. Meanwhile, for the VD SBI, an additional stretching enhanced by the secondary baroclinic vorticity (SBV) production contributes to the faster-mixing decay. The underlying mechanism of the SBV-enhanced stretching is further revealed through the density and velocity difference between the light shocked bubble and the heavy ambient air. By combining the SBV-accelerated stretching model and the initial shock compression, a novel mixing time estimation for VD SBI is theoretically proposed by solving the advection–diffusion equation under a deformation field of an axisymmetric vortex with the additional SBV-induced azimuthal velocity. Based on the mixing time model, a mixing enhancement number, defined by the ratio of VD and PS mixing time further, reveals the contribution from the VD effect, which implies a better control of the density distribution for mixing enhancement in a supersonic streamwise vortex.
Variable-density mixing in shock bubble interaction, a canonical flow of Richtermyer-Meshkov instability, is studied with high-resolution simulation. While the dissipation mainly controls the passive scalar mixing rate, an objective definition of variable-density mixing rate characterizing the macroscopic mixing formation is still lacking, and the fundamental behavior of mixing rate evolution is not yet well understood. Here we first show that the variable-density mixing of shock bubble interaction is distinctly different from the previous observations of the passive scalar mixing. The widely accepted hyperbolic conservation of the first moment of concentration in the scalar mixing, i.e., the conservation of the mean concentration, is violated in variable-density flows. We further combine the compositional transport equation and the divergence relation for the miscible flows to provide evidence that the existence of a density gradient accelerated mixing rate, decomposed by the accelerated dissipation term and redistributed diffusion term, contributes to the anomalous decrease or increase of the mean concentration depending on Atwood number. Further analyzing a number of simulations for the cylindrical or spherical bubbles under a broad range of shock Mach numbers, Reynolds numbers, and Péclet numbers, the density gradient accelerated mixing rate exhibits weak dependence on Péclet numbers, and we identify an Atwood number range with high mixing rate, which can be theoretically predicted based on the mode of hyperbolic conservation violation behavior.
A comprehensive theoretical model for the primary breakup of liquid jets in subsonic crossflow was developed. The model theoretically analyzed the jet deformation process, mass stripping process, and the influence of several critical forces and consequently provided highly accurate predictions of the jet trajectory. Deformation of the liquid jet cross section was considered as a two-stage process based on the physical characteristics, including the spring-mass analogy deformation and the mass stripping induced deformation. The mass stripping process was modeled as an exponential function of time based on experimental findings for liquid jets and droplets. Balance of critical forces acting on the jet were analyzed, both along the gas and jet flow directions, which included aerodynamic drag, viscous force, surface tension, and gravitation. The model provided precise prediction to the jet trajectory against experimental data without any initial jet velocity assumption across a wide range of gaseous Weber numbers and gas to liquid momentum ratios. In addition, quantitative effects of viscous force, surface tension force, and aerodynamic drag on jet trajectory were fully investigated based on the new model, which provided more insight into jet breakup characteristics and the effects of fuel properties on jet trajectory and deformation. Furthermore, the three-dimensional structure of the jet was reconstructed through the present model, which matched well against numerical results. Importantly, the current mathematical primary breakup model could be integrated with Lagrangian methods, obtaining more detailed vortex structures and accurate droplet dispersion with reduced computational time.