This article proposes an Energy Management System (EMS) for smart microgrids with a decentralized multi-agent system (MAS) based on a bio-inspired T-Cell optimization algorithm. The proposed system allows real-time control and dynamic balancing of loads while addressing the challenges of intermittent renewable energy sources like solar and wind. The system operates within the tertiary control layer; the optimal set points are computed by the T-Cell algorithm across energy sources and storage units. The set points are implemented and validated in real-time by the OPAL-RT simulation platform. The system contains a real-time feedback loop, which continuously monitors voltage levels and system performance, allowing the system to readjust in case of anomalies or power imbalances. Contrary to classical methods like Model Predictive Control (MPC) or Particle Swarm Optimization (PSO), the T-Cell algorithm demonstrates greater robustness to uncertainty and better adaptability to dynamic operating conditions. The MAS is implemented over the JADE platform, enabling decentralized coordination, autonomous response to disturbances, and continuous system optimization to ensure stability and reduce reliance on the main grid. The results demonstrate the system’s effectiveness in maintaining the voltages within acceptable limits of regulation (±5%), reducing reliance on the main grid, and optimizing the integration of renewable sources. The real-time closed-loop solution provides a scalable and reliable microgrid energy management solution under real-world constraints.

The operational integration of renewable energy into contemporary power systems requires accurate and dependable wind power forecasting, particularly in multi-site settings with nonlinear temporal dynamics, inter-site dependence, and forecast uncertainty. Static site conditioning, conditional variable selection, dynamic graph learning, encoder–decoder temporal fusion, interpretable temporal attention, quantile regression, and post hoc split conformal calibration are all combined in this work to create DG-TFT-CQR, a global multi-site historical-power-based probabilistic forecasting framework. A representative eight-site subset of the AEMO 5 Minute Wind Power benchmark was used to evaluate the model under four different forecasting settings: H1, H3, H6, and H12. The proposed model demonstrated the most balanced probabilistic behavior and the strongest overall point-forecasting performance over these horizons among the compared baselines. The MAE/RMSE/R² values for the point-forecasting results were 0.025490/0.043186/0.980096 at H1, 0.037241/0.062569/0.958221 at H3, 0.047917/0.079747/0.932133 at H6, and 0.062891/0.102751/0.887340 at H12. Additionally, the model preserved competitive interval sharpness while maintaining empirical coverage near the nominal 90% target. DG-TFT-CQR is the most robust balanced framework, with particularly evident advantages at H1 and H12, according to ablation, site-wise, daily case, statistical, and complexity analyses. In pairwise comparisons, H3 and H6 correspond to more mixed regimes. All things considered, the suggested approach offers a reliable and practically significant solution for multi-site wind power forecasting that takes uncertainty into account.

Modern microgrids face critical challenges in maintaining stability and efficiency due to renewable energy intermittency and dynamic load demands. This paper proposes a novel real-time energy management framework that synergizes a bio-inspired T-Cell optimization algorithm with decentralized voltage-based droop control to address these challenges. A JADE-based multi-agent system (MAS) orchestrates coordination between the T-Cell optimizer and edge-level controllers, enabling scalable and fault-tolerant decision-making. The T-Cell algorithm, inspired by adaptive immune system dynamics, optimizes global power distribution through the MAS platform, while droop control ensures local voltage stability via autonomous adjustments by distributed energy resources (DERs). The framework is rigorously validated through Hardware-in-the-Loop (HIL) testing using OPAL-RT, which interfaces MATLAB/Simulink models with Raspberry Pi for real-time communication (MQTT/Modbus protocols). Experimental results demonstrate a 91% reduction in grid dependency, 70% mitigation of voltage fluctuations, and a 93% self-consumption rate, significantly enhancing power quality and resilience. By integrating centralized optimization with decentralized control through MAS coordination, the hybrid approach achieves scalable, self-organizing microgrid operation under variable generation and load conditions. This work advances the practical deployment of adaptive energy management systems, offering a robust solution for sustainable and resilient microgrids.

This study proposes an enhanced control strategy to address critical challenges in microgrids with distributed energy sources, particularly voltage stability and power-sharing issues. The approach utilizes a Microgrid Central Controller (MGCC) in conjunction with droop control techniques. Evaluations using real-world meteorological data and MATLAB/Simulink demonstrate significant improvements in microgrid performance. The effectiveness of this strategy highlights the importance of advanced control in optimizing renewable energy microgrid performance, paving the way for advancements in sustainable energy management.

The integration of variable renewable energy sources (RES), such as solar and wind, into the microgrid through energy storage systems and controllable loads can destabilize the network. These factors cause power supply/demand imbalances, leading to voltage fluctuations and outages. In this article, a new optimization approach is proposed to address these challenges and to effectively manage the energy balance in microgrids. The study propose an Artificial Immune System inspired algorithm to identify optimal solutions and improve the power quality through power dispatch within the microgrid. Using the predicted renewable energy production data, the T-Cell algorithm executes calculations and sends them to a MATLAB environment for real-time simulation, which will make the system flexible in terms of dynamics and optimization of the power distribution using real-time data